Herein, the influences of CO2 dilution, N2 dilution, and CO2/N2 (in which half of the N2 is replaced by CO2) dilution on the combustion characteristics of a turbulent, partially premixed CO/H2–air flame were experimentally investigated in terms of the flame structure, flame temperature, and CO and CO2 concentrations in flames. TDLAS (tunable diode laser absorption spectroscopy) technique and an infrared gas analyzer were used for such purposes. CO2 dilution not only increases more momentum but also reduces the reaction rate. This results in a much longer flame length than that under N2 dilution. Compared with N2 dilution, the LH (axial length of the high-temperature reaction zone) values for the same levels of CO2 dilution and CO2/N2 dilution are much longer. The highest CO concentration in the CO2 diluted flame is higher than that in the CO/H2 flame and that in the CO2/N2 diluted flame is higher than in that the N2 diluted flame. The sizes of the main chemical reaction zone in CO2 and CO2/N2 diluted flames are larger than that in the N2 diluted flame. The inflection points in the rates of variation of the flame temperature and the CO and CO2 concentrations verify that CO2 dilution creates lower intensities and lower rates of chemical reactions, compared with N2 dilution.
Direct reduction of iron ore with H2 has become an alternative technology for iron production that reduces pollutant emissions. The reduction kinetics of iron ore fines in an H2 atmosphere under isothermal and non-isothermal conditions were studied by thermogravimetric analysis. X-ray diffraction and scanning electron microscopy were used to measure the mineral composition and analyse the morphology of the reduced fines, respectively. In the isothermal reduction experiment, it was found that the final reduction time was shorter, the higher the temperature, and the metallic iron particles formed a dense matrix structure. It is likely that the initial stages reduction process is the result of a combination of gaseous diffusion and interfacial chemical reaction mechanisms, and that the later stages a combination of interfacial chemical reaction and solid diffusion is the rate control mechanism. In the non-isothermal experiment, the heating rate had a significant effect on the reaction rate. The results show that the non-isothermal reduction proceeded through three stages: mixing control model, two-dimensional diffusion, and three-dimensional diffusion.