To evaluate the validity of cloud top height (CTH) retrievals from FY-4A, the first of China’s next-generation geostationary meteorological satellite series, the retrievals are compared to those from Himawari-8, CloudSat, Cloud-Aerosol Lidar and Infrared Pathfinder Satellite Observations (CALIPSO), and Moderate Resolution Imaging Spectroradiometer (MODIS) operational products from August to October 2017. Regarding CTHs from CloudSat, CALIPSO, and MODIS as truth, the results show that the performance of FY-4A CTH retrievals is similar to that of Himawari-8. Both FY-4A and Himawari-8 retrieve reasonable CTH values for single-layer clouds, but perform poorly for multi-layer clouds. The mean bias error (MBE) shows that the mean value of FY-4A CTH retrievals is smaller than that of Himawari-8 for single-layer clouds but larger for multi-layer clouds. For ice crystal clouds, both FY-4A and Himawari-8 obtain the underestimated CTHs. However, there is a tendency for FY-4A and Himawari-8 to overestimate the CTH values of CloudSat and CALIPSO mainly for low level liquid water clouds. The temperature inversion near the tops of water clouds may result in an overestimation of CTHs. According to the MBE change with altitude, FY-4A and Himawari-8 overestimate the CTHs mainly for clouds below 3 km, and the overestimation is slightly more apparent in Himawari-8 data than that in FY-4A values. As the cloud optical thickness (COT) increases, the CTH bias of FY-4A CTH retrievals gradually decreases. Two typical cases are analyzed to illustrate the differences between different satellites’ CTH retrievals in detail.

Utilizing the measurements and retrievals from the Global Precipitation Measurement dual‐frequency precipitation radar data during the summer of 2014–2020, this study analyzes the precipitation microphysics for summer rainfall over the Yangtze‐Huai River Valley (YHRV) region in China with respect to the precipitation efficiency index (PEI). The results show that the mean near‐surface rain rate and PEI for convective precipitation are generally larger than that for stratiform precipitation. There are larger raindrops in near‐surface rainfall for convective precipitation than that for stratiform precipitation. The High PEI precipitation is characterized by the larger ratio of convective precipitation samples compared to that for the other two categories of precipitation. The mean mass‐weighted mean diameter (D_m) of the near‐surface raindrops increase along with the precipitation top height (PTH) in Moderate PEI precipitation for convective and stratiform precipitating clouds. The larger PEI indicates the larger occurrence of the heavy raindrops and strong radar echoes near the ground. The growth process of raindrops falling below the melting layer in the High PEI precipitation is dominated by collision‐coalescence while the collisional break up is the dominant process below the melting layer in Low PEI precipitation. It is further verified that the microphysical characteristics and mechanisms of summer rainfall over the YHRV region are similar to that of precipitation derived from tropical cyclones over the ocean during the monsoon period.

Under the assumption that clouds are homogeneous and single-layered (SL), most current operational cloud top height (CTH) products derived from passive radiometers may largely underestimate the CTH of overlapping clouds. This article proposes a statistics-based extrapolation algorithm for retrieving the CTHs of overlapping clouds using only existing cloud property products available for most operational radiometers, and the method is successfully employed for the advanced himawari imager (AHI) observations. Because regional clouds within the same “system” have relatively continuous geometric properties, especially CTH, due to similar atmospheric conditions, upper-layer ice cloud CTHs (ITHs) and lower-layer water cloud CTHs (WTHs) are inferred using the CTH retrievals of well-chosen neighboring SL ice and water clouds, respectively. The proposed algorithm uses the latest machine-learning-based model to reasonably distinguish overlapping clouds from SL clouds, and optimizes the extrapolation by considering three physical constraints on neighboring, cloud phase, and cloud optical thickness (COT). Validated using active observations from CloudSat and cloud-aerosol Lidar and infrared pathfinder satellite observation (CALIPSO), our algorithm improves the AHI CTH mean bias for overlapping clouds from −5.1 to −2.6 km. More importantly, the algorithm provides CTH information of underlying water clouds that are unavailable from existing radiometer-based products. With the simultaneous retrieval of ITH and WTH, this algorithm increases our capability to detect the vertical structures of overlapping clouds and better evaluate the cloud radiative effects (CREs).

Earth observation, effectiveness orientation, remote sensing satellite, application engineering, space–ground integration, High Resolution Earth Eye Program

The current emphasis in the advancement of space-based synthetic-aperture radar (SAR) is on lightweight payloads under 100 kg with resolutions surpassing 1 m. This focus is directed toward meeting the launch criteria for multiple satellites on a single rocket and cutting costs. This article discusses the creation and progress of a Ku-band SAR payload for the Taijing-4(03) satellite, launched on 23 January 2024 and accompanied by four other satellites. The SAR payload design was customized to meet the demands of a micro-nano satellite platform, resulting in a lightweight, flat design weighing less than 80 kg, seamlessly integrated with the plate-shaped satellite platform. The article also introduces a beam optimization strategy for the phased array SAR antenna, significantly boosting the SAR system’s performance. The SAR payload provides various operating modes like slide-spot, strip, Scan 1, Scan 2, and others, with a maximum achievable resolution exceeding 1 m. Extensive in-orbit testing of the payload produced numerous high-quality SAR images with potential uses in emergency disaster mitigation, safeguarding ecosystems, monitoring forests, managing crops, tracking sea ice, and more.