A novel visible light-driven AgBr/AgCl@ZIF-8 catalyst was synthesized by a simple and rapid method. The composition and structure of the photocatalyst were characterized by XRD, SEM, UV-DRS, and XPS. It could be observed that the 2-methylimidazole zinc salt (ZIF-8) exhibited the rhombic dodecahedron morphology with the AgCl and AgBr particles evenly distributed around it. The composite photocatalyst AgBr/AgCl@ZIF-8 showed good photocatalytic degradation and antibacterial properties. The degradation rate of RhB solution was 98%, with 60 min of irradiation of visible light, and almost all P. aeruginosaudomonas aeruginosa (P. aeruginosa), Staphylococcus aureus (S. aureus), and Escherichia coli (E. coli) were inactivated under the irradiation of 90 min. In addition, the prepared catalyst had excellent stability and reusability. Based on the free radical capture experiment, ·O2− and h+ were believed to be the main active substances, and possible photocatalytic degradation and sterilization mechanisms of AgBr/AgCl@ZIF-8 were proposed.
In this study, two kinds of Co–Ni-layer double hydroxide (LDH)/ZnO films were prepared with different morphologies by a simple electrochemical method. The properties of the films were investigated by SEM, XRD, UV–Vis DRS, XPS, and electrochemical techniques. It was found that Co–Ni-LDH-modified ZnO films exhibited excellent photocathodic properties in a scavenger-free environment. This is mainly due to the absorption of visible light by LDH, the formation ofp–nheterojunction, and the depletion of photo-generated holes by the cycling process of Co (II)/Co (III). Compared with CoNi-LDH/ZnO nanorods, CoNi-LDH/ZnO nanoclusters showed better photocathodic protection performance and physical barrier effect. Under illumination conditions, the rough surface of ZnO nanoclusters and the deposition of a large amount of LDH can provide more photoelectrochemical active sites, thus improving the light absorption capacity and photocathodic protection performance of CoNi-LDH/ZnO nanoclusters. Under dark conditions, the physical barrier effect of CoNi-LDH/ZnO nanoclusters was also enhanced by the dense ZnO nanoclusters and thick CoNi-LDH layers.
The corrosion behavior of an AZ91D magnesium alloy was investigated under a heterogeneous electrolyte layer by using electrochemical methods and surface analysis techniques. Dynamic polarization curves and morphological characterization were obtained at the center and near the edge zones under the electrolyte layer. The influence of the gas/liquid/solid three-phase boundary zone (TPB) on the corrosion behavior of the AZ91D magnesium alloy was discussed. The corrosion rate changed more significantly near the TPB zone than that at the other zones. The AZ91D alloy exhibited the characteristics of filiform corrosion together with shallow pitting corrosion. Different from the randomly distributed shallow pits, the filiform corrosion preferred to initiate near the TPB region and then progressively expanded adjacent to the edge of the electrolyte layer. The TPB zone played a vital role in determining the corrosion location, the corrosion morphologies and the corrosion rate of the magnesium alloy by influencing the mass transport process of carbon dioxide.