Yaser A Khalaf

Prof. Yaser A Khalaf

Jouf University, Sakākā, Al Jawf, Saudi Arabia
orcid

Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 March 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
MYMahmoud A.M. Youssef
Mahmoud A.M. Youssef
AMAbdelrahman M. Mohamed
Abdelrahman M. Mohamed
Yaser A KhalafYaser A Khalaf
Yaser A Khalaf
YMYehia S. Mohamed
Yehia S. Mohamed
Not only are small photovoltaic (PV) systems widely used in poor countries and rural areas where the electrical loads are low but they can also be integrated into the national electricity grid to save electricity costs and reduce CO2 emissions. Partial shading (PS) is one of the phenomena that leads to a sharp decrease in the performance of PV systems. This study provides a comprehensive performance investigation of small systems (consisting of ten modules or fewer) under all possible shading patterns that result from one shading level (300 W/m2 is chosen). The most common configurations are considered for which a performance comparison is presented. Five small systems of different sizes are studied under PS. A new simplifying method is proposed to identify the distinct PS patterns under study. Consequently, the number of cases to be studied is significantly reduced from 1862 to 100 cases only. The study is conducted using the MATLAB/Simulink® environment. The simulation results demonstrate the most outperformed configuration in each case of PS pattern and the amount of improvement for each configuration. The configurations include static series-parallel (SP), static total-cross-tied (TCT), dynamic switching between SP and TCT, and TCT-reconfiguration. The study provides PV systems’ owners with a set of guidelines to opt for the best configuration of their PV systems. The optimum recommended configuration is TCT reconfiguration, rather than dynamic switching between SP and TCT. The less recommended option, which enjoys simplicity but is still viable, is the static TCT. It outperforms the static SP in most cases of PS patterns.

1 December 2007
Verified
Conference Paper
Closed access
HDHala Y. Darweesh
Hala Y. Darweesh
FFFathi A. Farag
Fathi A. Farag
Yaser A KhalafYaser A Khalaf
Yaser A Khalaf
This paper presents a new topology for an active capacitance multiplier. This circuit affords a technique to implement a high capacitance value using a small on-chip capacitor. The proposed capacitance multiplier is build up by cascading current multiplier cells (CMC). The circuit is preferred for low power low voltage applications since it is based on CMOS inverters and op-amps only. The capacitance multiplier is employed in the design of a second-order LPF with a programmable cutoff frequency. The cutoff frequency can be as low as 65 Hz using an on-chip capacitor of 1pF only. The static power dissipation is equal to 3 mW. Some practical considerations are discussed. The circuit is simulated using CMOS 0.13μm process. Simulation results show good agreement with the analytical calculations.

17 December 2002 in International Journal of RF and Microwave Computer-Aided Engineering
Verified
Journal Article
Closed access
PDF file
Yaser A KhalafYaser A Khalaf
Yaser A Khalaf
SRSedki M. Riad
Sedki M. Riad
A novel technique is developed for extracting the gate resistance, parasitic inductances, and pad capacitances for metal semiconductor field effect transistor devices. The parameters are extracted from two sets of S‐parameter measurements: cold measurements and pinch‐off measurements. The proposed technique gives rise to reliable results and it is insensitive to the unavoidable measurement errors over any frequency range. The technique is tested on hypothetical data and applied to S‐parameter measurements of a few metal semiconductor field effect transistor devices on the same wafer to provide a unique solution. © 2003 Wiley Periodicals, Inc. Int J RF and Microwave CAE 13: 62–73, 2003.

1 December 2007
Verified
Conference Paper
Closed access
AMAhmed Moussa
Ahmed Moussa
Yaser A KhalafYaser A Khalaf
Yaser A Khalaf
AKAhmed Khalil
Ahmed Khalil
A novel three port active circulator is proposed. The proposed circulator is composed of a phase divider with one transistor only, and a special form of Wilkinson power splitter operating as a power combiner. The circulator has been employed in FMCW radar front end with one antenna for both transmission and reception purposes. However, it can be used in other wireless communication transceivers. The circulator is designed and optimized at a center operating frequency of 2.45 GHz. Circulator simulations report good isolations for S 12 = -34 dB, S 31 = -24 dB, and S 13 = -13 dB with superior return losses for S 11 = -48 dB, S 22 = -25 dB, and S 33 = -51 dB.

1 December 2010
Verified
Conference Paper
Closed access
FFFathi A. Farag
Fathi A. Farag
Yaser A KhalafYaser A Khalaf
Yaser A Khalaf
This paper presents a new topology of a Digitally-Controlled current-mode-Variable-Gain-Amplifier “DCVGA”. A fully differential DCVGA is proposed, which improves the VGA performance. The proposed circuit is based on the current conveyor cell reported in. The circuit is suitable for low-power low-voltage applications since it is based on CMOS inverters. The proposed DCVGA achieves linear-in-dB gain variation at 1dB resolution. The variable gain is tuned from -5 to 36 dB. The proposed circuits have been designed and simulated using 0.13 μm IBM CMOS process. The simulation results show good performance in both gain-tuning ability and frequency response. Also, the 3-dB bandwidth is about 50 kHz at maximum gain. The power dissipation is 2.1mW from 1.5V supply voltage.

1 April 2011
Verified
Conference Paper
Closed access
IAI. L. Abdel-Hafez
I. L. Abdel-Hafez
Yaser A KhalafYaser A Khalaf
Yaser A Khalaf
FFF. A. Farag
F. A. Farag
A large dynamic range Programmable Variable Gain Amplifier (PVGA) suitable for Ultra Wide Band (UWB) applications is presented. The PVGA is composed of three variable gain amplifier stages followed by an output buffer. Such wide bandwidth allows our proposed PVGA to be used in multi-standard protocols. Power reduction is developed for the variable gain amplifier stages. The PVGA circuit is designed and simulated in a 0.13 um IBM-CMOS technology; it consumes 21 mA from a 1.5 V supply. The PVGA achieves 46 dB maximum gain with 48 dB gain dynamic range, a -43 dB THD at peak-to-peak differential output voltage of 800 mV and frequency 400 MHz. Moreover; the proposed circuit reports a good noise performance; the average integrated noise is 141 nV/vHz at minimum gain of -2 dB.