With the increasing application and study of lightweight and high strength fiber reinforced polymer composites in ocean industry, the structural failure problem of composite pressure hulls has attracted great attention from many researchers in China and globally. Analysis of the structural failure mechanisms is foundational to the design of deep-sea composite pressure hulls, since nowadays the design rules of pressurized vessels is mostly formulated according to their failure modes. Hence, this paper aims to review the research on the structural failure of composite pressure hulls in deep sea settings. First of all, the applied research status on composite material in marine equipment is analyzed, including inspection modalities for composite pressure hulls. The review then focuses on the three main failure modes, namely overall buckling, material failure and snap buckling of the deep-sea composite pressure hulls. The study identifies further problems of composite pressure hulls to be solved through the application of the deep sea equipment research, aiming to provide a reference for the study of mechanical behavior, ultimate strength computation, and design of thick composite pressure hulls for deep sea equipment.
To evaluate the collapse pressure of the steel–composite hybrid cylinders under external pressure without excessive computational cost, an analytical formula was derived in this study. The rationality of the derived formula was verified by the comparison with experimental and numerical results. The experimental results indicate that samples are manufactured and tested with good quality. The derived formula considered material failure and could reasonably predict the collapse pressure of the steel–composite hybrid cylinders with a maximum difference of 3.1%. Moreover, the effects of the wrap angle, thickness, and length on the collapse pressure of the hybrid cylinders were theoretically analyzed. The loading capacity of the hybrid cylinders was maximized under a wrap angle of ±55° for the composite layer. These findings are mainly because the hoop stress is twice the value of axial stress for a cylinder under uniform pressure.