Boiling water reactors have internal components manufactured with stainless-steel type 304. Some relevant cracks have been detected through the periodic inspections of their internal components. Regarding the core shroud, cracks have been observed along the circumferential welds. The causes of such cracks are: radiation, vibration, stress corrosion cracking (SCC) and residual stresses, acting alone or simultaneously. Initially, the material was ductile. However, it becomes brittle as hours of operation are accumulated. In the case of this paper, three asymmetric cracks, at the circumferential horizontal weld H7, have been postulated after 25 years of operation. The loading case considered was the combination of an earthquake with a loss of coolant accident (LOCA). The structural integrity was evaluated after 30 and 60 years of operation. In the last case, such evaluation was carried out during an extended period of operation of 30 years. In all cases, a fracture mechanics approach was followed. The results showed that one of such cracks was below the safety factor. In order to get an accurate evaluation, an elastoplastic and limit load analysis is required. This has been discussed in a companion paper.
Flow-induced vibrations occur in some of the internal components of a nuclear reactor. When specific conditions are present, these vibrations may result in excessive deformations or fatigue that can generate mechanical damage. Several boiling water reactor (BWR) of nuclear power plants (NPP) have experienced failures in the jet pump assembly due to flow-induced vibration (FIV) which could be caused by acoustic pulsations derived from recirculation pumps, vibration induced by turbulence and vibration induced by leakage at the slip joint. The purpose of this paper is to establish a viable numerical methodology to evaluate the fluid-structural interaction at the slip joint of a jet pump. In this analysis, the fluid-structural interaction was evaluated with the finite element method and finite volume method with ANSYS® code in the case of two steel plates with a divergent gap. Results show that a critical velocity could cause fluidelastic instability, if only one flow in a two-way fluid-structural interaction was considered. This is one of the phenomena that could take place at the slip joint of a jet pump assembly.
This paper shows the methodology used for the evaluation of the structural integrity of a boiling water reactor (BWR-5). This evaluation is relevant, because this vessel is the coolant pressure boundary for cooling the nuclear core. In the case of this paper, an axial crack is postulated in the adjacent internal wall of a vessel to the core, which is denominated beltline. Such a crack is subjected to an internal pressure and neutron irradiation. Additionally, a crack on the inlet nozzle of the low-pressure coolant injection (LPCI) was also considered. The analysis presented in this paper, evaluated the transient conditions which take place during the start-up and shutdown of a BWR 5. The neutronic irradiation damage at the beltline was also incorporated to the analysis. It induces an embrittlement. Linear elastic fracture mechanics was applied with the requirements established at the Appendix G of ASME Code Section XI. The finite element method was used to simulate the transient conditions of the components considering the critical parameter, such as the service temperature, thickness, stresses and the material properties.