The article presents a mathematical model of turbulent non-isothermal flow of viscoplastic fluid in a pipewith a sudden expansion of the heat network. Heat exchange of non-isothermal flow of viscoplastic fluid withcold environment leads to an increase in its viscosity and yield strength. Shvedov-Bingham rheological modelrepresents the viscoplastic state of fluid. The Reynolds Stress Model (RSM) turbulence model describes theproperties of anisotropy of the velocity components of pulsating motion in a pipe with a sudden expansion. Inaddition, the ability to predict turbulence anisotropy of the RSM model is used to construct a linear model ofturbulent viscosity. Calculation data are obtained for different values of Reynolds and Bingham numbers. Thecalculation results show that with an increase in the Bingham number, the circulation zone decreases behindthe section of the sudden expansion of the pipe. The results of the comparison of the radial profiles of thenormalized axial mean and fluctuation velocity with the experimental data along the pipe with sudden expansionare given. The results show the anisotropic property of the axial and radial profiles of the velocity of fluctuationmovement, which are in agreement with the data of the DNS (Direct Numerical Simulation) model.
This article presents a computational study of the influencing parameters on the solidification of the thermoplastic beryllium oxide slurry in an annular forming cavity. The main purpose of this paper is to study the effect of cooling and casting conditions on the solidification of the BeO suspension by considering the temperature-dependent rheological and physical properties. The results of calculations of the Bingham–Papanastasiou rheological model with experimental data in the intervals of phase transitions with different casting rates of beryllium ceramics have been validated. The use of the regularization parameter made it possible to approximate the flow of the slurry at all levels of its shear rates as highly viscous, followed by a continuous transition to a solid state. The speed of heat removal from the molding during the solidification period is determined by the speed of movement of the slurry and the temperature field on which the width of the transition region depends. The process of solidification of the slurry mass has been evaluated by changing its heat flow distribution and density along the length of the concentric channel. The obtained model calculation results make it possible to control the casting process and eventually realize a uniform structure of castings.