Protecting motor bearings from electric erosion is crucial as electric vehicles evolve. To better understand how lubrication interacts with electric discharge within motor bearings during varying speeds of vehicle operation, an optical ball-on-disk tribometer was modified to investigate the influence of alternating current (AC) electric fields on film thickness, friction force under various lubrication regions, and discharge characteristics. The study revealed that in AC electric fields, as the lubrication state shifts from mixed lubrication to fluid lubrication region, the electrical characteristic of the lubricating oil film changes from resistive to capacitive, accompanied by an increase in discharge frequency. Under the elastohydrodynamic lubrication (EHL) region, an electrical potential difference between the surfaces separated by the lubrication film leads to a reduction in film thickness, which can be attributed to the generation of Joule heating. If the potential difference across the oil film increases to the threshold voltage, destructive discharge occurs with the emission of a significant amount of purple light. Joule heating generated by the AC electric fields also results in a reduction in the friction coefficient under the fluid lubrication region. However, due to the reduction in film thickness, the lubrication state eventually moves to mixed lubrication, leading to a substantial increase in the friction coefficient. In addition, the study also investigated the use of grease with a nanographite conductive additive. It was found that inappropriate additive amounts can lead to discharge phenomena occurring outside the contact region.
The optimization of the lubricant supply quantity contributes to minimizing energy losses and wastage. To enhance the performance of hydrodynamic bearings running with limited lubricant supply (LLS), this study examined the effect of stearic acid as an additive. Stearic acid is commonly used for boundary lubrication as an organic friction modifier. How the stearic acid adsorption affects the hydrodynamic lubrication of a slider-on-disc contact under LLS was investigated using interferometry measurement and fluorescence observation in this study. Firstly, the oil reservoir of PAO10 with stearic acid adsorption was observed at the slider entrance. Secondly, the film thickness versus speed of PAO10 and PAO10 with 0.1% and 0.3% stearic acid, respectively, were measured. Finally, the morphology and surface properties of the glass and steel blocks with stearic acid adsorption were characterized by atomic force microscopy and Fourier transform infrared spectroscopy. The results show that the stearic acid adsorption layer weakens the wettability of the lubrication track and induces the ‘dewetting’ phenomenon of the lubricating oil. Thus, discrete oil distribution in the form of stripe or droplet can be generated, which leads to the accumulation of lubricating oil at the slider entrance to form a reservoir. An additional inlet pressure that is generated by the oil reservoir due to surface tension increases the oil film formation capacity. Furthermore, the morphologies of the adsorbed stearic acid layer on the glass and the steel blocks are, respectively, characterized by the nano-sized granular bulge and brush structure. This study reveals a new role of stearic acid adsorption in promoting LLS lubrication.
Limited lubricant supply (LLS) with tuned dosage is an emerging approach to reduce friction and energy consumption. However, LLS can cause severe starvation when the oil supply is insufficient. Therefore, how to effectively replenish oil to the lubricated contact in LLS operation is very important. Using a custom-made optical slider bearing test rig, this work experimentally revealed some characteristics of LLS lubrication in a cylinder-on-disc contact, and proposed two wettability gradient patterns, namely stripe wettability and interlaced wettability, to regulate the lubricant supply to improve the lubricating properties of LLS. The effect of these two wettability patterns was evaluated experimentally according to the lubricating film thickness. The interferograms of the bearing contact under LLS show that the two patterns can augment the oil replenishment through unidirectional lubricant transport by the unbalanced interfacial force via the wettability gradient. Moreover, the interlaced wettability pattern is more effective due to the discontinuous distribution of lubricant from its hydrophilic/hydrophobic region intervals and the transfer of the hydrophobic film to the hydrophilic regions.