The mathematical model of impedance response and the equivalent circuit model is determined based on electrochemical kinetics theory, and a method for calculating the kinetic parameters of the metal interface is presented.

The combined effect of salt and temperature on the corrosion behavior of X80 steel in silty soil was studied by microscopic and spectroscopic characterization techniques and electrochemical measurements.

This study investigates the deformation characteristics and base stability of a circular diaphragm wall support system (external diameter: 90 m, wall thickness: 1.5 m) with pit bottom reinforcement for the South Anchorage deep foundation pit of the Zhangjinggao Yangtze River Bridge, which uses layered and partitioned top-down excavation combined with lining construction. Through field monitoring (deep horizontal displacement of the diaphragm wall, vertical displacement at the wall top, and earth pressure) and numerical simulations (PLAXIS Strength Reduction Method), we systematically analyzed the deformation evolution and failure mechanisms during construction. The results indicate the following: (1) Under the synergistic effect of the circular diaphragm wall, lining, and pit bottom reinforcement, the maximum horizontal displacement at the wall top was less than 30 mm and the vertical displacement was 0.04%H, both significantly below code-specified thresholds, verifying the effectiveness of the support system and pit bottom reinforcement. (2) Earth pressure exhibited a “decrease-then-increase” trend during the excavation proceeds. High-pressure jet grouting pile reinforcement at the pit base significantly enhanced basal constraints, leading to earth pressure below the Rankine active limit during intermediate stages and converging toward theoretical values as deformation progressed. (3) Without reinforcement, hydraulic uplift failure manifested as sand layer suspension and soil shear. After reinforcement, failure modes shifted to basal uplift and wall-external soil sliding, demonstrating that high-pressure jet grouting pile reinforcement had positive contribution basal heave stability by improving soil shear strength. (4) Improved stability verification methods for anti-heave and anti-hydraulic-uplift were proposed, incorporating soil shear strength contributions to overcome the underestimation of reinforcement effects in traditional pressure equilibrium and Terzaghi bearing capacity models. This study provides theoretical and practical references for similar deep foundation pit projects and offers systematic solutions for the safety design and deformation characteristics of circular diaphragm walls with pit bottom reinforcement.

Constructing offshore wind turbines on artificial islands is considered a viable option, but negative skin friction (NSF) is a significant adverse factor that cannot be ignored. The NSF adversely affects the bearing capacity of pile foundations. Currently, design methods for studying the impact of NSF group effects mainly rely on empirical approaches. Moreover, existing experimental studies do not simulate the NSF experienced by offshore wind turbine pile groups on artificial islands. In order to further explore the impact of pile group effects on NSF experienced by offshore wind turbine pile foundations on artificial islands, this study conducted indoor model tests on single piles and 3 × 3 rectangular pile groups in sandy soil under uniformly distributed loading on surrounding soil. The experiment measured the settlement of piles at various positions within single piles and rectangular pile groups, as well as the settlement of the soil surrounding the piles and the NSF. Through calculations, the experiment determined the neutral points and NSF group effect coefficients for each pile. The results indicate that densely spaced pile groups are advantageous in reducing settlement of the surrounding soil, thereby mitigating the adverse effects of NSF. Due to the influence of pile group effects, different positions within the group experience varying degrees of NSF. Consequently, in practical engineering applications, settlement of both the pile groups and the surrounding soil should be calculated separately. Furthermore, design considerations for the uplift forces and neutral points of piles at different positions within the pile group should adhere to distinct standards.