Several studies have shown the synergetic benefits of combining various chemical enhanced oil recovery (CEOR) methods with engineered waterflooding (EWF) in both sandstones and carbonate formations. This paper compares the capillary desaturation tendency of various hybrid combinations of engineered water (EW) and CEOR methods with their conventional counterparts. Several coreflood experiments were conducted, including EW-surfactant flooding (EWSF), EW-polymer flooding (EWPF), EW-alkali-surfactant flooding (EWASF), EW-surfactant-polymer flooding (EWSPF), and EW-alkali-surfactant-polymer flooding (EWASP). Capillary numbers (Nc) and corresponding residual oil saturation (Sor) for each scenario are compared with capillary desaturation curves (CDC) of conventional CEOR methods from the literature. The results indicate that hybrid EW–CEOR methods have higher capillary desaturation tendency compared to conventional methods. The capillary numbers obtained by standalone polymer flooding (PF) are usually in the range from 10−6 to 10−5, which are not sufficient to cause a significant reduction in Sor. However, the hybrid EW-polymer flooding approach considerably reduced the Sor for the same Nc values, proving the effectiveness of the investigated method. The hybrid EWASP flooding caused the highest reduction in Sor (23%) against Nc values of 8 × 10−2, while conventional ASP flooding reduced the Sor for relatively higher Nc values (3 × 10−3 to 8 × 10−1). Overall, the hybrid methods are 30–70% more efficient in terms of recovering residual oil, compared to standalone EWF and CEOR methods. This can be attributed to the combination of different mechanisms such as wettability modification by EW, ultralow interfacial tension by alkali and surfactant, reduced surfactant adsorption by alkali addition, and favorable mobility ratio by polymer. Based on the promising results, these hybrid techniques can be effectively implemented to carbonate formations with harsh reservoir conditions such as high salinity and high temperature.
Engineered water surfactant flooding (EWSF) is a novel EOR technique to reduce residual oil saturation; however, it becomes quite challenging to obtain Winsor Type III microemulsion and the lowest IFT under actual reservoir conditions if only low salinity water is used. The main objective of this study was to design a negative salinity gradient to optimize the performance of the hybrid method. Three corefloods were performed on carbonate outcrop samples. The injection sequence in the first test was conventional waterflooding followed by optimum engineered water injection (2900 ppm) and finally an EWSF stage. The second and third tests were conducted using a varying negative salinity gradient. Engineered water for this study was designed by 10 times dilution of Caspian Sea water and spiking with key active ions. A higher salinity gradient was used for the first negative salinity gradient test. A total of 4300 ppm brine with 1 wt% surfactant was injected as a pre-flush after waterflooding followed by a further reduced salinity brine (~1400 ppm). The second negative salinity gradient test consisted of three post-waterflooding injection stages with salinities of 4600, 3700, and 290 ppm, respectively. Up to 8% and 16% more incremental oil recovery after waterflooding was obtained in the second and third tests, respectively, as compared to the first test. The descending order of brine salinity helped to create an optimum salinity environment for the surfactant despite surfactant adsorption. This study provided an optimum design for a successful LSSF test by adjusting the brine salinity and creating a negative salinity gradient during surfactant flooding. A higher reduction in residual oil saturation can be achieved by carefully designing an LSSF test, improving project economics.