With present-day standards and measurement techniques, it is very difficult to accurately predict the conducted interference levels of an electronic device connected to a power-line filter (PLF). In this paper, a new modal model (which takes into account common- and differential-mode interactions) for an electronic device is presented and tested. This model is used to develop a new methodology for the accurate prediction of the conducted emissions generated by a filtered electronic device. The modal point of view clarifies such phenomena as the loss of efficiency of PLFs and the modal energy exchange due to mismatches and asymmetries in the circuits. This methodology allows an automatic software selection or design of the optimum PLF for a given electronic device. It has been successfully tested using both test devices and actual electronic equipment.
23 June 2009 in IEEE Transactions on Power Delivery
With present day measurement techniques, it is very difficult to accurately model the power- line network (PLN), as seen from its power-line terminals, both in terms of impedance and noise. In this paper, a new circuital model (that considers line-ground and neutral-ground signals) and a new modal model (that considers common and the differential mode signals) for characterizing the low voltage PLN are presented. These models, which treat impedance and noise in a unified way, are composed by a three-impedance pi-network and two voltage sources. These models, which are complete and rigorous, are very interesting to desing PLC modems matched to the PLN for maximal power transfer, to compute the energy conversion between common mode and differential mode produced by asymmetries in the PLN, and to know the levels of differential mode noise that will affect a PLC receiver. These models have been experimentally validated.
8 February 2010 in IEEE Transactions on Electromagnetic Compatibility
In this paper, a new methodology to characterize common-mode chokes is presented. It is based on a model where common-mode and differential-mode interference is separated into different ports. This methodology is used to explain modal conversion inside common-mode chokes, predict the common-mode and differential-mode conducted emissions when common-mode chokes are connected to electric devices, and improve the filtering performance of common-mode chokes by finding the optimal common-mode choke parameters.
1 August 2012 in IEEE Transactions on Electromagnetic Compatibility
In this paper, a new circuit model and measurement methodology for the characterization of electric and electronic devices emitting nonstationary (as well as stationary) conducted emissions (CEs) are presented. The new circuit model combines a frequency-domain characterization of the passive behavior of a device, obtained from its S-parameter measurements, with a characterization of the CE sources obtained from time-domain measurements. It overcomes limitations of previous works providing a robust, efficient, and mathematically accurate description of the interference generation process, in particular in the nonstationary case. The validity and utility of this methodology are assessed by comparing its predictions with measurements performed according to standard procedures. Finally, it is shown how it can be effectively used in the computer-aided design of power-line filters for devices emitting nonstationary CE.
In coplanar waveguide (CPW) circuits, printed balanced antennas must be excited through baluns. These baluns often feature coplanar‐to‐slotline transitions that must be tuned and matched by electromagnetic optimisation, and may interfere with the antenna backward radiation. A new CPW balun for printed balanced antennas is presented and modelled. As its multimodal circuit model makes clear, it integrates an impedance‐matching network within its structure that can be analytically designed. The balun has been experimentally tested, exhibiting good agreement with its circuit model and a weak electromagnetic interaction with the antenna radiation.