Cold spray deposition of aluminum powders on polyethylene reinforced with glass fibers has been studied. Different processing conditions, including different stratifications of the fiber-reinforced polymer used as a substrate, have been investigated to better understand the deposition mechanism. The experimental campaign has been conceived and tailored to highlight the influence of several process parameters on the deposition of the first layer of particles. The results obtained allowed to highlight and clarify the influence of standoff distance and gas pressure and also gave some insights concerning the effect of the substrate stratification. Guidelines regarding the design of the manufacturing process have been also released.
12 October 2020 in Materials and Manufacturing Processes
The deposition of steel powders on glass fiber reinforced polymer (GFRP) with the Cold Spray technique is investigated. Metallization of composite materials is still challenging when high-strength and dense powders, such as steel, are used due to excessive erosion of the polymer or disruption of the fibers during the deposition. To overcome these issues, low-pressure cold spray equipment has been used for the experimental campaign shown in this paper. Different coatings were obtained by using nitrogen as the carrier gas and different sets of pressure and standoff distance. Optimization of the process parameters, including the stratification of the laminate, has been carried out. Results of an initial study of the feasibility of the process and the influence of the different chosen spray conditions are exposed. In particular, the bonding mechanisms of steel powders and their morphology are discussed.