River renaturation can be an effective management method for restoring a floodplain’s natural capacity and minimizing the effects during high flow periods. A 1D-2D Hydrologic Engineering Center–River Analysis System (HEC-RAS) model, in which the flood plain was considered as 2D and the main channel as 1D, was used to simulate flooding in the restored reach of the Spree River, Germany. When computing in this model, finite volume and finite difference approximations using the Preissmann approach are used for the 1D and 2D models, respectively. To comprehend the sensitivity of the parameters and model, several scenarios were simulated using different time steps and grid sizes. Additionally, dikes, dredging, and changes to the vegetation pattern were used to simulate flood mitigation measures. The model predicted that flooding would occur mostly in the downstream portion of the channel in the majority of the scenarios without mitigation measures, whereas with mitigation measures, flooding in the floodplain would be greatly reduced. By preserving the natural balance on the channel’s floodplain, the restored area needs to be kept in good condition. Therefore, mitigating measures that balance the area’s economic and environmental aspects must be considered in light of the potential for floods.
Distribution of the hyporheic streamlines and residence time (HRT) is a crucial factor under streambed to understand the transport phenomena of environmental toxins, sediment metabolic rates in fluvial ecology as well as hydrological water budget. To quantify HRT, both the laboratory and numerical approach could serve as discerning tools. However, due to high heterogeneity in natural streambed sediment and topography, an efficient numerical model setup can prove to be pragmatic in comparison to tedious laboratory experiments for tracing streamlines. Moreover, repeatability of results, high amount of variation in the laboratory flumebed setup, greater insight into the 3D flow system and investigation possibilities with regard to individual streamlines or particular areas of HRT distribution cannot be well executed in laboratory. On the other hand, an automated generation of hyporheic streamlines with a range of various flumebed setups could propel a better understanding of the process and behavior of hyporheic streamlines and HRT distribution. Therefore, a robust numerical method could bestow to trace a large number of particles from various seeding locations at the flumebed. All of these facts enforce the necessity of numerical modeling of flume experiments to perceive the hyporheic exchange mechanisms at fieldwork and research, which are difficult to segregate under natural in-stream conditions. Keeping these issues in mind, we developed an automated numerical method for quantifying the hyporheic exchange, where the surface water modeling software, HEC-RAS 5.0.5 and the subsurface flow and reactive transport code, MIN3P are coupled. A channel segment with a longitudinal dimension of 1 m and water surface elevation of 0.02 m is used for generating the hydraulic head distribution over the flumebed. A groundwater model domain of the dimensions of x:y:z = 1m:0.1m:0.1m is considered for the investigation of hyporheic exchange. A simple code for computing streamlines based on 4th order Runge-Kutta technique with the adaptive time integration method is developed using Matlab. Sensitivity analysis of streamline distribution and HRT to small scale changes (e.g. changes in dimension, distribution, and shape of the flumebed material) was performed, assuming a sand-gravel material mix. Various geometric shapes of gravel pieces (e.g. triangle, rectangle, trapezoid, and sphere) were used to vary the elevation of flumebed on a 1 mm scale. The results of the automated process show that the size, shape and distribution of trapezoidal gravel and sand portion in the streambed have a significant impact over hyporheic streamlines and HRT. High number and length of streamlines thus high HRT are found in case of the higher length of ridges created by the elevated portion of gravel pieces. In case of the increase of the length of gravel pieces along the longitudinal direction of flumebed, the length of streamlines and HRT decrease whereas the number of streamlines increase. Small scale hyporheic exchanges are found in case of increasing length of gravel pieces. Similar outcomes are also found for triangular and spherical gravel pieces. Both the number and length of streamlines are significantly reduced in case of the high number of gravel and sand portion on the streambed.
The environmental issues we are currently facing require long-term prospective efforts for sustainable growth. Renewable energy sources seem to be one of the most practical and efficient alternatives in this regard. Understanding a nation's pattern of energy use and renewable energy production is crucial for developing strategic plans. No previous study has been performed to explore the dynamics of power consumption with the change in renewable energy production on a country-wide scale. In contrast, a number of deep learning algorithms demonstrated acceptable performance while handling sequential data in the era of data-driven predictions. In this study, we developed a scheme to investigate and predict total power consumption and renewable energy production time series for eleven years of data using a Recurrent Neural Network (RNN). The dynamics of the interaction between the total annual power consumption and renewable energy production are investigated through extensive Exploratory Data Analysis (EDA) and a feature engineering framework. The performance of the model is found satisfactory through the comparison of the predicted data with the observed data, visualization of the distribution of the errors and Root Mean Squared Error (RMSE) value of 0.084. Higher performance is achieved through the increase in the number of epochs and hyperparameter tuning. The proposed framework can be used and transferred to investigate the trend of renewable energy production and power consumption and predict the future scenarios for different communities. Incorporation of the cloud-based platform into the proposed pipeline may lead to real-time forecasting.
River renaturation can be an effective management method for restoring the floodplain's natural capacity and minimizing the effects during high flow periods. A 1D-2D HEC-RAS model, in which the flood plain was considered as 2D and the main channel as 1D, was used to simulate flooding in the restored reach of the Spree River. When computing in this model, finite volume and finite difference approximations using the Preissmann approach are used for the 1D and 2D models, respectively. To comprehend the sensitivity of the parameters and model, several scenarios were simulated using different time steps and grid sizes. Additionally, dykes, dredging, and changes to the vegetation pattern have been used to simulate flood mitigation measures. The model predicted that flooding would occur mostly in the downstream portion of the channel in the majority of the scenarios without mitigation measures, whereas with mitigation measures, flooding in the floodplain would be greatly reduced. By preserving the natural balance on the channel's floodplain, the restored area needs to be kept in good condition. Therefore, mitigating measures that balance the area's economic and environmental aspects must be considered in light of the potential for floods.