Heat treatment of coprecipitated hydroxides in air has afforded isometric nanocrystals of rhombic yttrium, lanthanum, and gadolinium ferrites with average crystallite size 40±4 nm. It has been stated
The formation of bismuth orthoferrite under hydrothermal conditions at temperature 160, 180, or 200°С and pressure 100 MPa in aqueous solution of potassium hydroxide has been studied. The determined c
Synthesis and characterization of spherulite-like nanocrystalline titania with rutile structure (r-TiO2) are described herein. The r-TiO2 particles were synthesized via the convenient and low-cost hydrothermal treatment of TiO(C6H6O7) titanyl citrate. The r-TiO2 spherulites are micron-sized agglomerates of rod-shaped nanocrystals with characteristic sizes of 7(±2) × 43(±10) nm, oriented along (101) crystallographic direction, and separated by micropores, as revealed by SEM and TEM. PXRD and Raman spectroscopy confirmed the nanocrystalline nature of r-TiO2 crystallites. BET analysis showed a high specific surface area of 102.6 m2/g and a pore volume of 6.22 mm3/g. Photocatalytic performances of the r-TiO2 spherulites were investigated for the processes of methyl violet (MV) degradation in water and hydrogen evolution reaction (HER) in aqueous solutions of ethanol. The (MV) degradation kinetics was found to be first-order and the degradation rate coefficient is 2.38 × 10−2 min−1. The HER was performed using pure r-TiO2 spherulites and nanocomposite r-TiO2 spherulites with platinum deposited on the surface (r-TiO2/Pt). It was discovered that the r-TiO2/Pt nanocomposite has a 15-fold higher hydrogen evolution rate than pure r-TiO2; their rates are 161 and 11 nmol/min, respectively. Thus, the facile synthesis route and the high photocatalytic performances of the obtained nanomaterials make them promising for commercial use in such photocatalytic processes as organic contamination degradation and hydrogen evolution.
Lithium aluminosilicate glasses nucleated by TiO2 are usually melted in oxidizing conditions. The reducing conditions of glass melting, which allow to obtain ions of variable valence in lower oxidation states, can influence the ability of titania to provide proper phase assemblage, structure and properties of lithium aluminosilicate glass-ceramics. The aim of this study is to reveal this influence. The model glass containing TiO2 was melted with and without the addition of As2O3. Using heat treatments between 680 °C and 1300 °C, XRD, SEM and DSC data, Raman and absorption spectroscopy, transparent glass-ceramics based on nanocrystals of β-quartz solid solutions (ss) and/or γ-Al2O3 with spinel structure and opaque glass-ceramics based on nanocrystals of β-spodumene ss were obtained and characterized. Three-phase immiscibility develops during secondary heat treatments. Al2TiO5 crystallizes from aluminotitanate amorphous regions simultaneously with the appearance of β-quartz ss, while traces of anatase and then rutile appear at elevated temperatures. Phase assemblage and the sequence of phase transformations do not depend on the redox conditions of glass melting, while the rate of these transformations is significantly higher in glass melted without the addition of As2O3. Absorption in glass melted without the addition of As2O3 and the corresponding glass-ceramics originate from octahedrally coordinated Ti3+ ions and Ti3+-Ti4+ pairs in glass and nanocrystals of γ-Al2O3, Al2TiO5 and β-quartz ss. Transparent glass-ceramics with a thermal expansion coefficient of ~0.3 × 10−6 K−1 were obtained from both glasses.