In recent years, the production and application of biochar as a soil amendment produced from pruning residues has gained attention worldwide. Since the effect of grapevine rootstock type on grapevine-pruning residues used as feedstock for biochar production had not yet been researched, the present research was performed. Two grapevine rootstocks, different in vigor, were selected, with the hypothesis that they would affect their chemical composition and, consequently, the composition of the produced biochar. In this work, grapevine-pruning residues of the indigenous variety “Istrian Malvasia” (Vitis vinifera L.) grafted on 420A and SO4 rootstocks were analyzed and used for biochar production under three peak temperature programs (400 °C, 500 °C, and 600 °C). Higher pyrolysis temperature decreased yield but increased EC, ash, and TC content, as well as the content of most of the studied elements. On the other hand, grapevine rootstock type affected biochar EC, ash content, and specific surface area. Results showed that a more vigorous rootstock affects the produced biochar qualities by enhancing the above-mentioned properties. The present research showed that biochar produced from grapevine-pruning residues, especially at 500 °C or 600 °C, could be a valuable tool for the valorization of this biomass as a soil amendment.

Agricultural waste, which is produced in large quantities annually, can be a threat to the environment. Biochar (BC) production represents a potential solution for reducing the amount of grapevine pruning residues and, accordingly, the impact on the environment and climate change. Biochar produced by the process of pyrolysis from grapevine pruning residues was investigated and characterized to be applied as an adsorbent of polyphenolic compounds with the aim of using the waste from viticultural production to obtain a quality product with adsorption and recovery potential. Standards of caffeic acid (CA), gallic acid (GA), and oleuropein (OLP) were used as polyphenolic representatives. The obtained data were fitted with the Langmuir and Freundlich isotherms models to describe the adsorption process. The best K_L (0.39) and R² (0.9934) were found for OLP using the Langmuir model. Furthermore, the adsorption dynamics and recovery potential of BC were investigated using an adapted BC column and performed on an HPLC instrument. The adsorption dynamics of biochar resulted in the adsorption of 5.73 mg CA g⁻¹ of BC, 3.90 mg GA g⁻¹ of BC, and 3.17 mg OLP g⁻¹ of BC in a 24 h contact. The online solid phase extraction of the compounds performed on an HPLC instrument yielded a recovery of 41.5 ± 1.71% for CA, 61.8 ± 1.16% for GA, and 91.4 ± 2.10% for OLP. The investigated biochar has shown a higher affinity for low-polar compound adsorption and, consequently, a higher polar compound recovery suggesting its potential as an efficient polyphenolic compound adsorbent.

Onion peels (OP) are rich in bioactive compounds with a plethora of benefits for human health, but this valuable material is often wasted and underutilized due to its inedibility. Likewise, grapevine pruning residues are commonly treated as agricultural waste, but biochar (BC) obtained from this material has favorable characteristics as an adsorbent. This study investigated the potential of BC in removal of targeted polyphenolic compounds from OP extracts. The OP extracts were obtained adhering to green chemistry principles using deionized water amplified by three methods: maceration (MAC), ultrasound-assisted extraction (UAE), and microwave-assisted extraction (MAE). The extraction efficiency on the polyphenolic profile and antioxidant capacity was investigated with different extraction temperatures and solid-to-liquid (s/l) ratios. For further analysis, UAE at 90 °C with an s/l ratio of 1:100 was used due to higher polyphenolic compound yield. The BC adsorption capacity of individual polyphenols was fitted with the Langmuir and Freundlich isotherm models. Quercetin-3,4′-diglucoside obtained the highest R² coefficient in both models, and the highest q_max value. The optimum conditions in the dosage experiment suggested an amount of 0.5 g of BC using 3 g/L extracts. The studied BC showed a high affinity for targeted phytochemicals from OP extracts, indicating its potential to be applied for the green adsorption of valuable polyphenolic compounds.

Olive pomace (OP) contains phytotoxic compounds that can impair plant growth and soil quality. Composting provides an effective method for detoxifying olive pomace (OP) and improving its suitability for agricultural use. Therefore, this study investigated the phytotoxic effects of raw olive pomace filtrate (OPF) on seed germination in radish (Raphanus sativus L.) and barley (Hordeum vulgare L.), as well as the impact of composted olive pomace (COP) on their growth. Seeds were exposed to OPF at concentrations of 0% (control), 1%, 3%, 5%, 10%, 20%, and 100%. Additionally, three composting treatments were evaluated: R1 (control: OP + barley straw), R2 (OP + barley straw + urea), and R3 (OP + barley straw + sheep litter). Results showed that OPF at concentrations of 10%, 20%, and 100% significantly reduced seed germination, with complete inhibition at concentrations > 10%. The COP treatments showed different physicochemical properties, such as R2 exhibiting better nutrient availability (C/N = 19, oil content = 0.04%). R3 had the highest concentrations of K (40,430.2 mg/kg) and P (6022.68 mg/kg). Results also indicated that R1 significantly reduced radish dry biomass production compared to barley, although R2 performed slightly better than R1 and R3. The findings highlight the need for proper compost stabilization to minimize the phytotoxicity and improve the agricultural potential of COP for improving soil health.

Biochar has attracted interest in viticulture for its potential to enhance nutrient uptake and improve grapevine physiology under changing climatic conditions, particularly in Mediterranean regions. However, the widespread adoption of biochar has been limited due to economic and logistical constraints associated with its large-scale application. To address these barriers hindering the widespread adoption of biochar, this study investigates the effects of foliar-applied water suspensions of biochar at concentrations of 300 mg/L (B300), 600 mg/L (B600), and 1200 mg/L (B1200), compared to a water-only control (C), as a practical alternative application method. The research focused on Malvazija istarska (Vitis vinifera L.), an indigenous Croatian grapevine variety, conducted in an experimental vineyard in Poreč, Croatia. The key physiological parameters examined included photo-synthetic activity, leaf water potential, the elemental composition of the grapevine leaves, and grape yield. Foliar applications were administered three times during the growing season, with five replicates per treatment. The results indicated that biochar treatments had no significant impact on photosynthetic activity, suggesting that foliar application did not cause leaf shading. However, higher biochar concentrations (B600 and B1200) led to increased leaf concentrations of nitrogen (2.1–3.8%), potassium (10.1–18.4 g/kg), sulfur (2.2–2.5 g/kg), boron (65.1–83.6 mg/kg), and manganese (42.4–69.8 mg/kg) compared to B300 and C treatments. Conversely, magnesium content decreased (2.1–2.7 g/kg), likely due to potassium–magnesium antagonism. Furthermore, the B600 treatment produced the highest grape yield (2.67 kg/vine), representing up to a 37% increase compared to other treatments. These findings suggest that the foliar application of biochar can be an effective and sustainable strategy to enhance vineyard productivity. Moreover, it offers a circular economy approach by valorizing grapevine pruning waste as a biochar source.

Given today’s increasingly intensive agriculture, one key problem area considers the valorization and reuse of wastes from food and agricultural production with minimal impact on the environment. Due to its physicochemical characteristics, biochar (BC) derived from grapevine pruning residue has shown considerable potential for use as an adsorbent. High-value phytochemicals found in abundance in the olive leaf (OL) can be employed in many different industrial sectors. The potential application of BC in the removal of specific polyphenolic components from OL extracts has been investigated in the present study. Water, as the most available and greenest of solvents, was investigated as to its use in the extraction of polyphenols, which was carried out by comparing maceration, ultrasound-assisted extraction, and microwave-assisted extraction, considering different temperatures and solid-to-liquid (s/l) ratios. The BC adsorption capacity of selected polyphenols was fitted with both the Langmuir and Freundlich isotherm models. The Freundlich model fitted better relative to OL polyphenols adsorption. Oleuropein was the most abundant compound identified in the extracts, obtaining the highest K_f value (20.4 (mg/g) × (L/g)ⁿ) and R² coefficient (0.9715) in the adsorption on the biochar’s surface. The optimum conditions in the dosage experiment suggest the use of 0.5 g of BC using 3 g/L extracts, with an exception for oleuropein and hydroxytyrosol, for which the highest biochar dose (2.5 g) performed better. Considering the compounds’ concentrations and the BC dose, BC from grapevine pruning residues demonstrated a potential use in the uptake of specific polyphenols from olive leaves, making it a promising adsorbent for such applications.