The present work intends to characterise the combination of two netted software defined radios (SDR) and different radio frequency (RF) front‐ends installed in them, together with a two‐stratum time dissemination and synchronisation system. A modified implementation of the Network Time Protocol is used as coarse event synchronisation for either SDR back‐end. The White rabbit light embedded node implementation of the commonly known white rabbit synchronisation system (IEEE 1588 PTP‐2019) or arbitrary wave form generators are used as fine time dissemination system for either SDR. The resulting netted transceiver system is intended to compose a demonstrator for proof‐of‐concept experiments. The findings presented in this article show that the chosen combination of hardware and software is suitable for radar applications operating within L‐, S‐ and C‐bands. A channel coherency throughout the network with a relative modified Allan deviation of less than 80 fs for averaging intervals of 1 s, a phase noise better than −118 dBc/Hz at 10 Hz frequency offset and a fractional frequency lower than was measured. Within a single transceiver node, a fractional frequency lower than and phase noise of −124 dBc/Hz at 10 Hz frequency offset were measured as well. Multistatic radar systems exploit wide spatial diversity to enhance target detection and tracking, albeit with increased complexity when compared to a monostatic configuration. To exploit these benefits, all participating transceiver nodes within the netted radar need to synchronise to a common time base . The achieved synchronisation level increases the accuracy with which the chain of timed events at the transmitter and at the receiver side occur, intending to maximise the signal‐to‐noise ratio available at the receiver. The Universal software radio peripheral model X310 with two different daughterboard models as RF front‐end was used as SDR on either radar node. A network combining data and synchronisation purposes allowed the radar nodes under test to operate synchronously. The two‐stratum synchronisation system used glass fibres between 2 m and 5 km of length or coaxial cables with 2 m in length for network traffic, time and frequency dissemination purposes. The multiple RF front‐ends were stimulated by means of arbitrary waveform generators with calibrated traceability. Up‐chirp and sinusoid waveforms were used as stimuli for measuring the offset of either channel with regards of to ultimately estimate the achievable coherency limits of the system under test. Both analogue and digital evaluation methods were considered.

Time synchronization and positioning of bistatic radar transceivers is required to coordinate and meaningfully merge the measurements made between them. It simultaneously allows the radar transceivers to change their position throughout time. Despite their acknowledged vulnerabilities, Global Navigation Satellite Systems (GNSSs) are the preferred source for Positioning, Navigation and Timing (PNT) services. Because of these vulnerabilities however, research on possible signal sources to obtain alternative positioning, navigation and timing (A-PNT) is of interest. This present work proposes the use of a narrow-band transponder installed on a geostationary (GEO) satellite to be used as one anchor for a future time transfer. A channel calibration is made between the transceiver station and the chosen satellite. Diverse models are used to estimate the channel effects throughout the signal propagation path, estimate the time delay, and correct the measurements, accordingly. The available channel bandwidth on the proposed satellite is 2.7 kHz, limiting the accuracy of the time measurements. After integration of multiple pulses, a time accuracy of approximately 1 μs is obtained. The range measurements are compared against satellite positions propagated from publicly available two-line element sets (TLEs). The obtained results suggest that, after calibration, the expected accuracy and a good repeatability is obtained. Thus, making the QO-100 satellite a suitable anchor for the proposed technique.