ASAKURA Hiroshi

Prof. Dr. ASAKURA Hiroshi

Nagasaki University, Nagasaki, Japan
orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2015 in Waste Management
Verified
Journal Article
Open access
ASAKURA HiroshiASAKURA Hiroshi
ASAKURA Hiroshi
In order to suggest a limit value for gypsum (CaSO4) for the suppression of hydrogen sulfide (H2S) generation at an inert solid waste landfill site, the relationship between raw material (SO4 and organic matter) for H2S generation and generated H2S concentration, and the balance of raw material (SO4) and product (H2S) considering generation and outflow were investigated. SO4 concentration should be less than approximately 100mg-SO4/L in order to suppress H2S generation to below 2000ppm. Total organic carbon (TOC) concentration should be less than approximately 200mg-C/L assuming a high SO4 concentration. The limit value for SO4 in the ground is 60mg-SO4/kg with 0.011wt% as gypsum dihydrate, i.e., approximately 1/10 of the limit value in inert waste as defined by the EU Council Decision (560mg-SO4/kg-waste). The limit value for SO4 in inert waste as defined by the EU Council Decision is high and TOC is strictly excluded. The cumulative amount of SO4 outflow through the liquid phase is much larger than that through the gas phase. SO4 concentration in pore water decreases with time, reaching half the initial concentration around day 100. SO4 reduction by rainfall can be expected in the long term.

1 January 2021 in Biocontrol Science
Verified
Journal Article
Open access
PDF file
MUMasashi Uema
Masashi Uema
KYKenzo Yonemitsu
Kenzo Yonemitsu
YMYoshika Momose
Yoshika Momose
YIYoshikazu Ishii
Yoshikazu Ishii
KTKazuhiro Tateda
Kazuhiro Tateda
ASAKURA HiroshiASAKURA Hiroshi
ASAKURA Hiroshi
There is a worldwide attempt to develop prevention strategies against SARS-CoV-2 transmission. Here we examined the effectiveness of tungsten trioxide (WO3)-based visible light-responsive photocatalyst on the inactivation of SARS-CoV-2 under different temperatures and exposure durations. The viral titer on the photocatalyst-coated glass slides decreased from 5.93 ± 0.38 logTCID50 /mL to 3.05 ±. 25 logTCID50/mL after exposure to 3,000 lux of the visible light irradiation for 6h at 20℃. On the other hand, lighting without the photocatalyst, or the photocatalyst-coat without lighting retained viral stability. Immunoblotting and electron microscopic analyses showed the reduced amounts of spike protein on the viral surface after the photocatalyst treatment. Our data suggest a possible implication of the photocatalyst on the decontamination of SARS-CoV-2 in indoor environments, thereby preventing indirect viral spread.

17 September 2023 in Microplastics
Verified
Journal Article
Open access
PDF file
ASAKURA HiroshiASAKURA Hiroshi
ASAKURA Hiroshi
Environmental pollution by microplastics (MPs) has become a growing concern, and not only professional researchers but also the citizenry are needed to understand the pollution situation and to confirm the decreasing trend of MP pollution as a result of the global reduction in plastic use. In this study, the author evaluated the accuracy of a simple method of investigating MPs on sandy beaches that can be conducted even by high school students. In a land survey using simple tools such as a tape measure and cardboard, the maximum coefficient of variation is approximately 1%. Even without heavy liquid, 89% of MPs could be recovered using only seawater. An investigation of MP content by sampling 0.5 cm of the surface layer of sand could explain more than half of the MP content when the sand was sampled to a depth of approximately 50 cm below the surface layer. A method in which the recovered MPs are not visually sorted but floating matter after boiling is considered as MPs is acceptable. If there was no concern about pumice contamination, the overestimation was approximately 1.5 times. Simple laboratory equipment such as buckets, sieves, seawater, hot plates, dryers, and electronic balances could achieve lower limits of quantification of MPs of 13 mg-MPs/m2-sand and 2 mg-MPs/kg-sand.

1 November 2010 in Waste Management
Verified
Journal Article
Closed access
ASAKURA HiroshiASAKURA Hiroshi
ASAKURA Hiroshi
KEKazuto Endo
Kazuto Endo
MYMasato Yamada
Masato Yamada
YIYuzo Inoue
Yuzo Inoue
YOYusaku Ono
Yusaku Ono
YOYoshiro Ono
Yoshiro Ono

Verified
Journal Article
Open access
PDF file
ASAKURA HiroshiASAKURA Hiroshi
ASAKURA Hiroshi
Plastic waste’s near-permanent pollution of the natural environment is becoming an increasing concern. It is necessary to determine the amount of microplastics (MPs) present in the natural environment and reduce the amount of plastic waste. In this study, the author developed a simple sorting method for MPs in sediment, which can eliminate sediment and does not require filtration, using an apparatus available to the public. This sorting method, called the “bottle method”, can shut off floating matter from sediment and be used for sorting and washing at the same time. When the density of the solid sample is lower than the liquid density, the recovery rate is almost 100%, as theoretically predicted. The recovery rate of MPs by the bottle method is comparable to that by the other two methods, i.e., the spoon method and the overflow method, and the sorting time is reduced by approximately half. As for the dilution of the liquid by the bottle method, the ratio of actual concentration to theoretical concentration is in the range 0.86 to 1.36, and the dilution and washing of the liquid proceeds as theoretically predicted.

10 April 2024 in PeerJ
Verified
Journal Article
Open access
PDF file
ASAKURA HiroshiASAKURA Hiroshi
ASAKURA Hiroshi
Long-term microplastics (MPs) environmental pollution trends cannot be understood only by investigating their presence on beaches. Without estimating MPs for the entire beach, comparisons between multiple beaches cannot be made. In this study, Nagasaki Prefecture was selected as the study site, we measured MPs accumulation rate to express the MPs pollution trend and weighted the measurement results to enable comparison of MPs content among multiple sandy beaches. The MPs accumulation rate in the study site was measured by periodic investigation at fixed spots. The average in the supratidal zone was 1.5 ± 0.9 mg-MPs/(m2-sand⋅ d) (n = 15). The weighting of the MPs content in hot spots and non-hot spots by their respective areas enabled us to obtain the representative value and the dispersion of the MPs content in the entire study site. The MPs contents in the three beaches were 298 ± 144, 1,115 ± 518, and 4,084 ± 2,243 mg-MPs/(m2-sand), respectively. Using these values, it is possible to compare the MPs contents of multiple beaches.