The Cameros Basin (North Spain) is a Late Jurassic‐Early Cretaceous extensional basin, which was inverted during the Cenozoic. It underwent a remarkable thermal evolution, as indicated by the record of anomalous high temperatures in its deposits. In this study, the subsidence and thermal history of the basin is reconstructed, using subsidence analysis and 2D thermal modelling. Tectonic subsidence curves provide evidence of the occurrence of two rapid subsidence phases during the syn‐extensional stage. In the first phase (Tithonian‐Early Berriasian), the largest accommodation space was formed in the central sector of the basin, whereas in the second (Early Barremian‐Early Albian), it was formed in the northern sector. These rapid subsidence phases could correspond to relevant tectonic events affecting the Iberian Plate at that time. By distinguishing between the initial and thermal subsidence and defining their relative magnitudes, Royden's (1986) method was used to estimate the heat flow at the end of the extensional stage. A maximum heat flow of 60–65 mW/m2 is estimated, implying only a minor thermal disturbance associated with extension. In contrast with these data, very high vitrinite reflectance, anomalously distributed in some case with respect to the typical depth‐vitrinite reflectance relation, was measured in the central‐northern sector of the basin. Burial and thermal data are used to construct a 2D thermal basin model, to elucidate the role of the processes involved in sediment heating. Calibration of the thermal model with the vitrinite reflectance (%Ro) and fluid inclusion (FI) data indicates that in the central and northern sectors of the basin, an extra heat source, other than a typical rift, is required to explain the observed thermal anomalies. The distribution of the %Ro and FI values in these sectors suggests that the high temperatures and their distribution are related to the circulation of hot fluids. Hot fluids were attributed to the hydrothermal metamorphic events affecting the area during the early post‐extensional and inversion stages of the basin.
Fault‐related dolomitisation is responsible for the development of numerous hydrocarbon reservoirs hosted in diagenetically‐altered carbonates and is therefore critical to hydrocarbon exploration, subsurface storage (i.e. CO2), the formation of associated mineralisation (i.e. MVT‐deposits) and for understanding the key controls on subsurface fluid flow. Multiple dolomitised outcrop analogues have been characterised in recent years, but uncertainty still remains as to the controls on dolomitisation in terms of dolostone geobody size and geometries, their distribution and how they impact reservoir quality. Late Tithonian shallow‐marine carbonates at Serra Esparreguera in the Maestrat Basin (E. Spain) were partially dolomitised on the seismic scale, resulting in a spectrum of geobodies with varying degrees of spatial connectivity. Dolostone predominantly replaces Polpís Fm wackestones and packstones, and bioclastic grainstones of the Bovalar Fm. Dolostone geobodies transition through vertical stratigraphy from being massive and spatially extensive to localised stratabound bodies as textural heterogeneity increases. Irregular dolostone geometries occur in the Polpís Fm, which is texturally homogenous relative to the overlying Bovalar Fm, cross‐cutting bedding in areas with high abundance of faults. Faults occur adjacent to dolostone and constrain its lateral extent across the outcrop. Dolomitisation fronts are typically sharp with morphologies affected by small‐scale faults and bedding‐parallel stylolites. Dolomitisation occurred under burial conditions and dolostones were later overprinted by phases of calcite and saddle dolomite cementation. The spatial distribution of dolostone is strongly influenced by the depositional heterogeneity and faults, while smaller structures (i.e. metre‐scale fractures and stylolites) and bedding surfaces controlled the dolomitisation front geometry. Dolostone geobodies at Serra Esparreguera provide new insights into the structural, depositional and diagenetic controls on dolomitisation at a seismic scale, which can be used as a predictive guide to improve the understanding of carbonate reservoirs with complex paragenetic histories.
Iberia and its oceanic margins provide evidence of a large rift system developed in three phases: i) late Permian–Middle Triassic, ii) Late Jurassic, and iii) Barremian–early Albian. These rifting events were coeval with the opening of the Alpine Tethys, the North-Atlantic, and the Bay of Biscay domains, respectively. The three Mesozoic rifting phases controlled the development of Iberian intraplate rift basins, including the Maestrat and Garraf basins, which are the focus of this study. Each of these rifting stages was followed by a period of decelerated or post-rift thermal subsidence. The first post-rift phase, spanning the Late Triassic to the early Late Jurassic, was interrupted by a short-lived interval of rapid syn-rift subsidence during the Hettangian, here referred to as the Hettangian event. Rifting cycles 2 and 3 are separated by the Neocomian event, which corresponds to an interval of decelerated subsidence. The earliest rifting phase is associated with an early inception of saline tectonics in the Maestrat Basin, and was accompanied by magmatism and took place in an arid climate setting, whereas the second and third rifting stages were essentially amagmatic and occurred under humid (sub)tropical conditions. The structural style during polyphase rifting is characterized by extensional systems involving the uppermost part of the crust, with basal faults located at a depth of 7 to 10 km. The Maestrat and Garraf basins developed during the Barremian–early Albian period were bounded by decakilometric normal faults with kilometric dip-slip, and were later inverted during the Paleogene contraction, giving rise to the fold-and-thrust systems of the Iberian and Catalan Coastal chains. Vertical movements, uplift and fault-induced subsidence, and the prevailing climate conditions were the two principal controls on the sedimentary record of the Iberian intraplate rift basins.
A correlation between planktonic foraminifera and ammonite biostratigraphic biozonations has for the first time been established for the lower Aptian of the Morella sub-basin (northern Maestrat Basin). The planktonic foraminifera zones recognized are Globigerinelloides blowi, Globigerinelloides aptiensis, Leupoldina cabri and Hedbergella luterbacheri. The identified ammonite zones include the Deshayesites forbesi, Deshayesites deshayesi and Dufrenoyia furcata zones, and the Roloboceras hambrovi and Deshayesites grandis subzones. The boundary between the G. aptiensis and L. cabri zones was recorded in the uppermost part of the Deshayesites forbesi Zone, coinciding with the middle part of the R. hambrovi Subzone. The H. luterbacheri Zone spans almost the entire Deshayesites deshayesi Zone and the whole Dufrenoyia furcata Zone. The Oceanic Anoxic Event (OAE1a) has also been calibrated against the two biostratigraphic schemes. This event spans almost all the G. aptiensis and the basal part of the L. cabri planktonic foraminifera zones and largely coincides with the R. hambrovi ammonite subzone. This study provides an extended and accurate biostratigraphic framework for the Morella sub-basin, helping to better constrain the age of stratigraphic intervals where ammonites are scarce or absent, that may also serve as a correlation tool for the analysis of other coeval marine sedimentary successions in the western Tethys.
In the current work, three relevant new ammonite finds from the Maestrat Basin are reported and analyzed from a biostratigraphical point of view. Additionally, another important ammonite, originally published in the late 1950th, is reviewed. The relevance of these four specimens lies in the fact that they come from stratigraphic intervals in the Maestrat Basin where ammonites are exceptionally rare. The purpose of this study was to analyze these ammonites from the latest Barremian-Aptian interval from a biostratigraphic perspective, with the goal of accurately determining the age of the stratigraphic intervals. The analysis of these ammonites has confirmed the age of previously defined transgressive-regressive sequences within the Maestrat Basin and led to the revision of some of these age assignments. To enhance the correlation potential of the Maestrat Basin within a broader context, its sedimentary and ammonite records have been compared with one European basin and one North African basin. This more precise ammonite-based age calibration significantly advances the chronostratigraphic understanding of sequence stratigraphy in the Maestrat Basin, establishing it as one of the best age-calibrated basins of the Tethys. Thus, the Maestrat Basin serves as a key reference point for correlating other Tethyan basins within this time interval.