Landfilling is one of the most common methods that are used in the final disposal of sludge world wide, as well as in Turkey. However, increasing sludge quantities and limited landfilling areas make this method difficult to apply. The use of sludge in agriculture presents a possible alternative for disposal. However, it also poses some risks to be evaluated. In this respect, it is important to identify the heavy metal content of sewage sludges because of its adverse health effects. This study aims to determine the heavy metal contents of sludges and wastewaters from three different wastewater treatment plants in Turkey. The selection of plants was carried out according to the different treatment technologies applied to wastewater and sludge in those plants. Heavy metal analysis of sludges and wastewaters was conducted using a microwave assisted digestion procedure. After sampling and analysis, the results show that all the related metal concentrations are below the values that are set in the Soil Pollution Control Regulation of Turkey. However, in two of the three plants, Zn and Ni concentration should be tracked carefully.
19 July 2024 in Macromolecular Rapid Communications
In this study, six different donor‐π‐acceptor1‐π‐donor‐acceptor2 type random co‐polymers containing benzodithiophene as a donor, benzooxadiazole (BO), and thieno[3,4‐c]pyrrole‐4,6‐dione (TPD) as acceptor, have been synthesized and characterized. In addition to the acceptor core ratio at different values, the effect of aromatic bridge structures on the optical, electronic, and photovoltaic properties of six different random co‐polymers is investigated by using thiophene and selenophene structures as aromatic bridge units. To investigate how the acceptor unit ratio and replacement of aromatic bridge units impact the structural, electronic, and optical properties of the polymers, density functional theory (DFT) calculations are carried out for the tetramer models. The open‐circuit voltage (VOC), which is strongly correlated with the HOMO levels of the donor material, is enhanced with the increasing ratio of the TPD moiety. On the other hand, the short‐circuit current (JSC), which is associated with the absorption ability of the donor material, is improved by the increasing ratio of BO moiety with the π‐bridges. BO moiety dominant selenophene π‐bridged co‐polymer (P4) showed the best performance with a power conversion efficiency (PCE) of 6.26%, a JSC of 11.44 mA cm2, a VOC of 0.80 V, and a fill factor (FF) of 68.81%.
5 November 2025 in Journal of Macromolecular Science, Part A