27 July 2023 in IEEE Transactions on Aerospace and Electronic Systems
The interrupted sampling repeater jamming (ISRJ) produces multiple false targets after pulse compression, making it difficult for radar to detect real targets. In this paper, an anti-ISRJ algorithm is developed based on the joint design of the waveform and mismatched filter with expanded mainlobe. First, to prevent false alarms when the range sidelobes and jamming peaks of the filter output are too high, the sum of the peak sidelobe level of the waveform compressed with mismatched filter and the peak level of the ISRJ signal compressed with mismatched filter is taken as an optimization criterion for minimization. Meanwhile, a penalty function is used to control the mainlobe shape of the correlation function between the mainlobe. To maximize the transmitted power efficiency of the radar and control the signal-to-noise ratio loss caused by the mismatched filter, a constant modular constraint for the waveform and an energy constraint for the filter are adopted. Then, an iterative algorithm based on the majorization– minimization framework is proposed to solve the joint design problem. In each iteration, an analytical expression is derived to realize the simultaneous updating of the waveform and filter. The convergence of the proposed algorithm is proven, and its computational complexity is analyzed. Finally, simulations are provided to demonstrate the effectiveness of the proposed algorithm. Compared with existing algorithms, the waveform and filter designed in this paper exhibit better pulse compression performance and anti-jamming ability.
9 November 2017 in IEEE Transactions on Geoscience and Remote Sensing
The existing methods for motion compensation in inverse synthetic aperture radar (ISAR) imaging are generally limited to the low-order target motion model, and require iterative optimization with limited velocity estimate precision and heavy computational burdens. This paper proposes a high-precision method of phase-derived velocity measurement (PDVM) and applies it to motion compensation of ISAR imaging. The method applies PDVM based on range profiles cross correlation to the translational velocity estimation of targets, and converts the velocity measurement results to the corresponding range increment. The equivalent phase-derived range measurement precision can reach the order of magnitude of millimeter (mm) or even sub-mm, which can satisfy the precision requirements of both envelope alignment and phase adjustment. The key to realizing PDVM is resolving phase ambiguity. The traditional method for resolving ambiguity has very high requirements for the signal-to-noise ratio (SNR). This work resolves ambiguity by combining multiframe data, i.e., by resolving ambiguity of multiframe data simultaneously instead of resolving ambiguity of single-frame data independently and correcting the above ambiguity-resolving results using a minimum-entropy method. Therefore, phase ambiguity can be correctly resolved under a relatively low SNR. Experimental results of an ISAR imaging of an airplane show that the method proposed in this paper can obtain high-quality ISAR imagery, and can efficiently realize robust imaging under the conditions of low SNR.
18 November 2019 in IEEE Transactions on Aerospace and Electronic Systems
13 July 2022 in IEEE Transactions on Signal Processing
Pulse-Doppler radar systems with medium/high pulse repetition frequencies (PRFs) usually produce severe range ambiguities, and strong nearby ground/sea clutter will then fold into a single range interval with weak remote target echoes, further limiting the dynamic range of radar. The existing methods for modeling or estimating clutter spectra are usually not applicable to the case of folded clutter. In recent years, pulse-agile waveforms have attracted an increasing amount of attention for resolving range ambiguities. However, cross-correlations among pulse-agile waveforms with the same frequency band, usually required for pulse-Doppler radar to coherently measure the Doppler shift, are not satisfactory for suppressing folded clutter since clutter echoes are much stronger than those of targets. In this paper, two algorithms based on the method of alternating projection (MAP) in the range-Doppler domain (RD-MAP) and the space-Doppler domain (SD-MAP) are proposed to suppress folded clutter and resolve range ambiguities for pulse-Doppler radar based on different types of pulse-agile waveforms. The effectiveness of these algorithms is verified based on several realistic simulations and a ground-based experiment. Iterative solutions and closed-form solutions are both provided for different computational complexity and accuracy requirements in certain application scenarios. Moreover, algorithm analysis, including algorithm boundary analysis, signal-to-noise ratio (SNR) loss, computational complexity and factor selection, is performed to provide an estimation of the applicable conditions and assess the performance of the proposed algorithms.
20 January 2021 in IEEE Transactions on Aerospace and Electronic Systems
Finding codes for the desired autocorrelation function (ACF) based on phase-coded modulation waveforms has always been a popular research topic, and the relevant literature is abundant. However, the optimized ACF may not be obtained in band-limited hardware due to the extended spectral sidelobes generated by instantaneous phase changes. Polyphase-coded FM (PCFM) waveforms based on continuous phase modulation (CPM), which uses a shape filter to smooth phase jumps, can provide effective spectral containment. However, for PCFM waveforms using the existing optimized phase codes, the original desired property of the ACF, e.g., a low integrated sidelobe level (ISL) or weighted ISL (WISL), will not be obtained because of the smoothness among all phases. Hence, PCFM waveforms based on CPM should be redesigned and optimized. Moreover, designing pulse-agile waveforms with different phase codes to mitigate range ambiguity has also attracted increased attention in recent years. However, different waveforms will yield range sidelobe modulation (RSM) in Doppler processing, which degrades the attendant Doppler coherency, leading to high sidelobes in the Doppler dimension. In this article, optimization algorithms for designing diverse PCFM waveforms and relevant joint mismatched filters (JMMFs) are proposed. A CPM-based cyclic algorithm (CPM-CA) using the method of alternating projection for optimizing the PCFM waveform with a desired ACF is proposed in the first step. The design of multiple diverse PCFM waveforms with similar ACFs and a small RSM effect is also considered. Then, to further optimize the ISL/WISL and reduce the RSM effect, a novel method for designing JMMFs using a cyclic algorithm (JMMF-CA) is proposed. Simulations and an experiment based on a real radar system indicate that the optimized PCFM waveforms and JMMFs using CPM-CA and JMMF-CA can yield a desired ISL/WISL while achieving a small RSM effect with a low loss of signal-to-noise ratio and satisfactory Doppler robustness.