21 August 2022 in Advances in Materials Science and Engineering
This article studies the effect of microstructure on the corrosion fatigue crack growth behavior of low and medium carbon steels. 45 steel and 15CrMo were selected and five typical microstructures were obtained by different heat treatment processes. The microstructures of 45 steel and 15CrMo after annealing and normalizing are both ferrite and pearlite, but the proportions of ferrite and pearlite in the four microstructures are different. The quenching and tempering microstructure of 45 steel is tempered fine pearlite. Corrosion fatigue tests were conducted on specimens with different microstructures of the two materials. Expressions of corrosion fatigue crack growth rate and da/dNΔK fitting curves of different microstructures were obtained. Comparison of da/dN∼ΔK curves of 45 steel shows that tempered fine pearlite has the best resistance to corrosion fatigue crack growth, and the content of pearlite has a great impact on the corrosion fatigue crack growth behavior for specimens with the microstructure of ferrite and pearlite. In the low ΔK region, the corrosion factor plays a dominant role in fatigue crack growth, and the corrosion resistance of pearlite is weak, which leads to a higher da/dN in the normalized state. In the high ΔK region, fatigue factor dominants, since the fatigue resistance of pearlite is strong, da/dN of the annealed state is higher. The experimental results of 15CrMo showed the same crack growth rate change regulation as that of 45 steel, which further proves the effect of pearlite on the corrosion fatigue crack propagation behavior.
1 April 2011 in Advanced Materials Research
To investigate the relationship of surface electromyogram (sEMG) and handgrip force, a measurement system was developed. Ten healthy subjects were required to perform a series of static contraction trials by maintaining the force level with maximal voluntary contraction (MVC), 75%MVC, 50%MVC and 25%MVC respectively. Then they sustained MVC as long as possible until fatigue. The handgrip force and sEMG on the forearm muscles were recorded. Root mean square (RMS), mean power frequency (MPF) and median frequency (MF) of the sEMG were calculated with LabVIEW. The results show that RMS increased with force level during voluntary contraction, while MPF and MF shift to lower frequency during fatigue condition. These findings suggested that the designed system can be used to study forearm function.
30 September 2026 in Physical Chemistry Chemical Physics
Grain boundaries in polycrystalline graphene strongly scatter phonons while having a relatively limited impact on charge carriers. This effect and an enhanced Seebeck coefficient synergistically increase the ZT value.