21 April 2025 in IEEE Transactions on Microwave Theory and Techniques
We propose and demonstrate a photonic-assisted joint radar and communication (JRC) system using a JRC signal with overlapped spectrum to support simultaneous wideband ranging and high-speed communications. For radar ranging, an electrical linearly-frequency-modulated (LFM) waveform is modulated on an optical carrier at a Mach-Zehnder modulator (MZM) biased at the null point to generate odd-order sidebands. By filtering out the first-order sidebands, two third-order sidebands are obtained. By beating the two sidebands at a photodetector (PD), a frequency-sextupled electrical LFM with sextupled bandwidth is generated. For wireless communications, a binary phase-shift keying (BPSK) or quadrature phase-shift keying (QPSK) signal is modulated on one of the third-order sidebands. By beating the modulated sideband with the other unmodulated sideband, a frequency upconverted wireless signal is generated. The JRC signals are radiated to free space. At the radar receiver, the echo signal is applied to another MZM where the signal is optically dechirped to extract the target information. At the communication receiver, the JRC signal is received and applied to an MZM, where the radar and the communication signals beat to generate the original communication signal. Since no local oscillator (LO) signal is employed, the system is greatly simplified. The dual functions of the system are evaluated by an experiment. For radar ranging, a wideband LFM radar signal with a 9.6-GHz bandwidth is generated, and radar ranging with a high range resolution of 2.5 cm is obtained. For wireless communication, a 4-GBaud/s BPSK and a 2-GBaud/s QPSK signal are transmitted over 20 m, with the bit error rates (BERs) of $1.82\times 10^{-5}$ and $1.96\times 10^{-5}$ , respectively, which are below the forward error correction (FEC) limit for error free communications.
28 February 2025 in Journal of Lightwave Technology
An extended microwave-photonic iterative nonlinear gain (MING) model is proposed to analyze the mode competition dynamics in an optoelectronic oscillator (OEO). The power trajectories of multiple longitudinal modes in the mode competition process are calculated using the proposed extended MING model, by which we observe that mode competition is affected by the loop nonlinearity. On one hand, when the nonlinearity is enhanced, gain saturation effect becomes more significant. The strongest mode will gain the most energy from the optical carrier and win the competition, leading to single-mode oscillation. On the other hand, with enhanced nonlinearity, the intermodulation distortions (IMDs) become more significant. The mixing between the longitudinal modes would lead to energy transfer, causing weaker longitudinal modes to receive more energy, thereby hindering mode competition. Therefore, through suppressing the IMDs by reducing the loop gain, multi-mode operation can be reduced, facilitating stable single-mode operation. The mode competition dynamics of an OEO at different loop gain levels is evaluated by simulations. The simulation results show that by decreasing the loop gain, multi-mode oscillation is quickly evolved to single-mode oscillation, which is validated by an experiment. The proposed extended model is the first comprehensive study of the nonlinear dynamics of an OEO, showing the evolution from an initial multimode oscillation to a stable single-mode oscillation.
23 April 2024 in IEEE Transactions on Microwave Theory and Techniques
A new microwave photonic signal processor for use in a frequency diverse array (FDA) to generate a dot-shaped beampattern is presented. The microwave photonic signal processor is implemented based on a dual-polarization quadrature phase shift keying (DP-QPSK) modulator and a phase modulator (PM), with the amplitude and phase of an input radio frequency (RF) signal controlled by the bias voltages to the DP-QPSK modulator, and the frequency offset to the RF signal is realized by Serrodyne modulation at the PM. The operation of the signal processor is analyzed theoretically and demonstrated experimentally. The results show that the proposed signal processor can generate an RF signal with arbitrary controlled amplitude and phase and a frequency offset ranging from $-$ 240.2 to 8.4 kHz. A dot-shaped beampattern generated by a 32-element nonuniform FDA is calculated using the experimentally generated RF signals. The beampattern exhibits a low peak sidelobe level (PSLL) of 0.3443 and narrow angle and range half power beamwidth of 7.69 $^{\circ}$ and 2.35 km, respectively.
20 September 2024 in IEEE Transactions on Microwave Theory and Techniques
We propose and demonstrate a microwave photonic distributed radar system for target positioning based on joint polarization and sideband multiplexing to enable four radar transceivers to share a single optical wavelength. The system consists of an indoor unit and an outdoor unit with four transceivers. The indoor unit is responsible for the generation of a linearly frequency-modulated (LFM) optical waveform which is split and sent via optical fibers to the four individual radar transceivers at the outdoor unit. After photodetection at the transceivers, four LFM microwave waveforms are generated and transmitted. When reflected by a target, four echo signals are received which are polarization and sideband multiplexed and transmitted back to the indoor unit. At the indoor unit, the multiplexed optical signal is demultiplexed and undergoes a photonic de-chirp process. The time delays are estimated by measuring the frequencies of the de-chirped signals, which are then used for target positioning. The proposed radar system is validated through a 3-D spatial target positioning experiment. The results show that the system can locate a target with a spatial positioning accuracy within $\pm$ 3 cm.
25 September 2025 in Journal of Lightwave Technology
The gain margin of an optoelectronic oscillator (OEO) is the range of gain (RoG) over which stable single-mode oscillation is maintained without being switched to oscillations in multi-mode. A large RoG indicates a stable single-mode oscillation against gain variations due to environmental perturbations. For an OEO incorporating an electrical bandpass filter (EBPF) and an electrical amplifier (EA), we propose to increase the RoG by reducing the bandwidth of the EBPF and by reducing the saturation output power of the EA. The proposed scheme is studied by numerical simulations and is verified by an experiment. The simulation results based on the extended microwave-photonic iterative nonlinear gain (eMING) model show that reducing the bandwidth of the EBPF from 1 GHz to 20 MHz, the RoG is increased by 5.5 dB. Additionally, lowering the saturation output power of the EA from 16 dBm to 3 dBm, the RoG is increased by 9 dB. The simulation results are then verified by an experiment. Experimental results demonstrate a 3.6 dB improvement in RoG by reducing the bandwidth of the EBPF from 1 GHz to 20 MHz. Similarly, the RoG shows a 2.6 dB improvement by lowering the saturation output power of the EA from 16 dBm to 3 dBm. This work provides an effective solution to maximize the stable single-mode operation range of an OEO without complicating the system architecture.
17 June 2025 in IEEE Photonics Technology Letters
We propose a photonic microwave frequency measurement system with kHz resolution for the instantaneous measurement of the Doppler frequency shift (DFS)of a moving object. By joint use of an optical frequency comb (OFC) generator implemented by cascading an intensity modulator (IM) and a phase modulator (PM) and a high-Q metal-coated micro-disk resonator (MDR), an ultra-sensitive amplitude comparison function (ACF) for frequency-to-power mapping is established, which enables ultra-high sensitivity frequency measurement. The proposed technique is experimentally demonstrated. A Doppler signal is applied to the two modulators to generate multiple sidebands corresponding to an optical comb. By aligning the ±3-rd order sidebands with the steep slopes of two adjacent notches of the metal-coated MDR, an ACF is obtained. A frequency measurement sensitivity of 2.28 dB/MHz is experimentally achieved. With a power measurement resolution of 0.01 dB, the frequency measurement resolution is 4.37 kHz, which is the highest ever reported based on photonic techniques. It enables Doppler frequency shift measurement for an object moving at speeds between 40.34 to 1384 m/s.