Wenyue Tang

Wenyue Tang

Auto-generated profile, based on publicly available information

Wenyue Tang

State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi’an Jiaotong University , Xi’an, Shaanxi 710049

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2023 in Review of Scientific Instruments
Verified
Journal Article
Open access
PDF file
SWShaofei Wang
Shaofei Wang
CZCheng-Ru Zhu
Cheng-Ru Zhu
WTWen-Yue Tang
Wen-Yue Tang
PZPu-Qing Zhang
Pu-Qing Zhang
YXYan-Zhao Xie
Yan-Zhao Xie
In this paper, a kind of tightly coupled array (TCA) with time-domain beam scan is developed for the radiation of high-power ultrawideband (UWB) electromagnetic pulses, and the peak-power pattern is proposed to characterize the directivity. First, the active voltage standing wave ratio (AVSWR) bandwidth of the TCA is optimized, which is the precondition for the beam scan. It indicates that the lower-cutoff frequency (LCF) is inversely proportional to the total length of the whole array; an increase in the distance between the array and the ground plane could remarkably reduce the LCF; and an increase in the element number can also decrease the LCF because of the increase in length, but more elements would make the center elements difficult to match in the low-frequency range, so there is a limitation on the number of elements for a certain LCF. Based on these results, a six-element linear array is designed. Then, the definition of the peak-power pattern is proposed to characterize the directivity of the UWB pulsed antenna. Finally, the optimized six-element array is developed, and the measured working band is 276 MHz–6.4 GHz (AVSWR < 3). The effective potential gain is 1.76, and it improves by 51.7% with a reduction in the aperture area by 68.4% compared with the previous TCA, which means that the aperture efficiency is remarkably improved. The half-power beam width of the developed TCA with the scan angle of 0° is 45°. The time-domain beam scan could be performed with time-delay feeding lines, and the maximum scan angle is over ±30° in the E-plane. The developed TCA can be applied for the generation of high-power electromagnetic environments for the study of intentional electromagnetic interference.

14 May 2024 in IEEE Transactions on Power Delivery
Verified
Journal Article
Closed access
SWShaofei Wang
Shaofei Wang
CZChengru Zhu
Chengru Zhu
YXYanzhao Xie
Yanzhao Xie
WTWenyue Tang
Wenyue Tang
In this paper, a novel method for the detection of external insulation defects based on the ultrawideband impulse radar is proposed. The circular synthetic aperture radar method was adopted to collect reflected signals in this paper, since the detected object often has a symmetric shape (e.g., insulators, bushings, etc.). The mean suppression method is adopted to filter out the clutters of reflected waveforms from different directions, and thus the reflected signals of defects can be amplified. Then, the defect images are extracted from the processed reflected signals with the back projection algorithm. Moreover, since the example objects studied here are of multi-layer circular structure with different dielectrics for each layer, the accurate wave-propagation time should be calibrated before the calculation of back projection amplitudes. Thus, the multi-layer model is established to figure out the refraction path, while the propagation time is compensated based on the wave speeds of different dielectrics. The non-destructive detection capacity of the proposed UWB detection method is verified by the simulation first, and then the practical detection effectiveness is verified by the comparison experiment of an intact insulator and a defective one. The experimental results indicate that the measured length of the internal crack as an extension of the observed surface cavity is about 30 mm, and the severest defect point is only 4.2 mm away from the latter, which means the defect locating is of high accuracy. The investigation results demonstrate that, due to the good penetrability and imaging resolution, the impulse radar exhibits good potential in the online detection of both surface and internal defects of the external insulation equipment.

1 January 2026 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
CZChengru Zhu
Chengru Zhu
SWShaofei Wang
Shaofei Wang
YCYiheng Chen
Yiheng Chen
WTWenyue Tang
Wenyue Tang
KLKai Lu
Kai Lu
YXYanzhao Xie
Yanzhao Xie

1 June 2016
Verified
Conference Paper
Closed access
WTW. Tang
W. Tang
DSD. Shiffler
D. Shiffler
MLM. LaCour
M. LaCour
KGK. Golby
K. Golby
TKT. Knowles
T. Knowles
Field emitter arrays have the potential to provide high current density, low voltage operation, and high pulse repetition for radar and communication. It is well known that packing density of the field emitter arrays significantly affects the emission current1. Previously we conducted experiments using two-and four-cathode configurations. Here we extend our previous work and present experimental results for nine cathodes in a square and cylindrical configuration. The experiments used nine cathodes with variable spacing to investigate the effect of electric field screening on current emission. Emission characteristic is compared for the case of two, four and nine field emitters with different spacing. Particle-in-cell simulations are performed to compare with the experiments.

1 December 2025 in Review of Scientific Instruments
Verified
Journal Article
Closed access
SWShaofei Wang
Shaofei Wang
WTWenyue Tang
Wenyue Tang
WLWanting Liu
Wanting Liu
ZKZefei Kou
Zefei Kou
YXYanzhao Xie
Yanzhao Xie
In this article, a broadband sub-array decoupling method based on a surface-wave-induced absorption mechanism is proposed to enable the compact design of two-dimensional (2D) tightly coupled arrays (TCAs) for the radiation of ultrawideband (UWB) pulses. Decoupling of UWB pulsed antenna arrays is more complicated than that of conventional narrowband arrays, since the mutual coupling itself occurs over a rather broad frequency range. Moreover, for a UWB pulse radiation system, significant gain loss within the decoupling band is undesirable, because it should maintain high waveform fidelity in the radiation fields. Thus, the mutual coupling mechanism between subarrays in the 2D TCA should be studied, and novel decoupling methods should be proposed. It indicates that the sub-array mutual coupling is caused by the surface wave between them, whose polarization direction is along the sub-array axis. Therefore, a resistive decoupling chain (RDC) is arranged along the sub-array direction between them to induce and absorb the coupling energy through the metal leads and the resistors, respectively. The former act as receiving antennas, while the latter act as loads. Therefore, the isolation between the subarrays and the bandwidth of the 2D TCA is improved. Finally, a 4 × 8-element TCA loaded with RDC is developed, and the sub-array mutual coupling is significantly reduced. The operating bandwidth of the developed TCA has been extended to 0.35–3.93 GHz. In terms of the time-domain performance, the pulse fidelity of the radiating fields after loading the RDC reaches 0.998. Moreover, the measured effective potential of the developed TCA with RDC is 4.61 kV, and the effective potential gain is 1.44, which is almost the same as that without RDC. It demonstrates that the proposed RDC can achieve broadband decoupling without noticeable loss in both frequency- and time-domain gains for the radiation of UWB pulses, compared with the existing decoupling methods.