30 November 2022 in Energy & Environmental Science
Identifying an ideal microstructure for efficient thermoelectric materials has been complicated by the interplay between the electrical and thermal properties. The electrical properties of thermoelectric materials are often compromised to reduce lattice thermal conductivities and increase dimensionless thermoelectric figure-of-merit (zT). However, the increase in zT achieved using this strategy has recently stagnated. For example, elemental tellurium (Te) has exhibited a degraded zT of ∼1 for several years although it has gained considerable attention as a potential high-performance thermoelectric material. In this study, we demonstrate an unprecedentedly high zT of 1.42 at 623 K for 1% Fe2As-doped elemental Te crystals by utilizing the doping-induced twisting behavior of grain boundaries in Te. The unconventional twisted microstructure—twisted boundaries with aligned helical chains—enables an “electrically textured and thermally random” orientation. Therefore, the twisted Te crystal has a higher electrical conductivity and a comparable lattice thermal conductivity to the polycrystalline Te.
28 March 2022 in RSC Advances
The silver paste was synthesized by a hydrometallurgical method from waste catalyst.
1 February 2026 in Journal of Micromechanics and Microengineering
In optical systems, where miniaturization is the dominant trend, flat optical components capable of active aberration correction are increasingly required. SmartLens enables tunable wavefront control by locally modifying the refractive index of a transparent thermo-optic polymer using a microscale heater. However, such heaters are typically fabricated through complex multistep photolithography. In this study, we designed and simulated a Fresnel zone plate (FZP)-based microheater geometry to optimize optical efficiency and aberration control. The optimized FZP-shaped heater is fabricated by direct laser writing on a 70 nm-thick chromium (Cr) film and coated with a 1.1 mm-thick polydimethylsiloxane layer to enable thermo-optic modulation. A pronounced coma aberration was generated under off-axis conditions and subsequently compensated through electrically induced thermo-optic wavefront modulation. The fabricated SmartLens demonstrated correction of the off-axis coma aberration, which was quantitatively verified using point spread function and modulation transfer function analyses, including the reduction of directional anisotropy and the convergence of orthogonal full width at half maximum values.
15 September 2026 in Nanoscale Advances
A simple aqueous self-reduction strategy enables highly dispersed Pt nanoparticles on a SWCNT/γ-Al 2 O 3 support. The hybrid architecture enhances Pt dispersion and delivers nearly fivefold higher CO oxidation activity than Pt/γ-Al 2 O 3 .