The effects of recycled powder (RP) on hydration, micro-structures, compressive strength and tensile properties of high-ductility cementitious composites (HDCC) were studied. Three mass ratios of RP ranging from 10, 30 to 60% were employed to partially replace the cement. The hydration kinetics of RP-amended matrix was measured to investigate the influence of RP on the cementitious hydration process and the phase development was quantified by the thermal gravimetric analysis. Mechanical properties, including the compressive and tensile properties of HDCCs were obtained at 28 days. The morphology of reinforced polyethylene fiber at the fracture surface was obtained by the environmental scanning electron microscope (SEM) analysis.
Concrete‐filled tubular flange girders have been used in bridges, and torsional bracings are widely used in them to increase the lateral‐torsional buckling strength. This article proposes an analytical solution for the lateral‐torsional buckling (LTB) of concrete‐filled tubular flange steel girders with torsional bracing under a concentrated load. The modal trial functions of lateral displacement and the torsional angle are expressed by the first six terms of the trigonometric function. By introducing dimensionless parameters, the variational solution of energy for the buckling equation of the LTB of the girders is obtained, and the formula for the dimensionless critical moment of its LTB is derived using 1stOpt based on 32,550 data sets. Compared with the finite element method, the proposed critical formula is highly accurate and can be applied to engineering design. Finally, parametric studies were conducted on the effects of the stiffness of torsional bracing, the span of the girder, and the flange steel ratio.
1 November 2020 in IOP Conference Series: Earth and Environmental Science
In order to study the stress characteristics of steel corbel column under eccentric pressure, the corbel column is regarded as a cantilever column for theoretical analysis based on engineering mechanics, and the analytical solution of structural stress of corbel column is obtained. The three-dimensional finite element models of three kinds of corbels are established by using ABAQUS software. The static analysis under eccentric load is carried out, and the stress distribution of corbel columns is obtained. The results show that changing the loading position will have a great impact on the stress state of the structure, and finding out the reasonable loading position can make the component better exert its mechanical performance. Finally, the reasonable loading position and structural measures of the single corbel column in this project are proposed, which can provide reference for similar projects.
1 February 2021 in IOP Conference Series: Earth and Environmental Science
In order to study the axial compression performance of the GFRP tube reactive power concrete composite short column with encased steel, a finite element model of the composite short column was established. The constitutive models of steel, RPC and GFRP were selected. The element selection and contact method of each component were explained. The boundary condition and mesh division of the composite column were determined. Based on this, finite element verification analysis of 6 specimens was performed by ABAQUS. The load-displacement curves and the axial compression bearing capacity were obtained. By comparing with the test, the reasonability of the constitutive model and the finite element model of this kind of column is verified.