23 August 2021 in Sports Biomechanics
The aim of this study was to review the literature on front crawl swimming biomechanics, focusing on propulsive and resistive forces at different swimming velocities. Recent studies show that the resistive force increases in proportion to the cube of the velocity, which implies that a proficient technique to miminise the resistive (and maximise the propulsive) force is particularly important in sprinters. To increase the velocity in races, swimmers increase their stroke frequency. However, experimental and simulation studies have revealed that there is a maximum frequency beyond which swimmers cannot further increase swimming velocity due to a change in the angle of attack of the hand that reduces its propulsive force. While the results of experimental and simulation studies are consistent regarding the effect of the arm actions on propulsion, the findings of investigations into the effect of the kicking motion are conflicting. Some studies have indicated a positive effect of kicking on propulsion at high swimming velocities while the others have yielded the opposite result. Therefore, this review contributes to knowledge of how the upper-limb propulsion can be optimised and indicates a need for further investigation to understand how the kicking action can be optimised in front crawl swimming. Abbreviations: C: Energy cost [kJ/m]; Ė: Metabolic power [W, kJ/s]; Fhand: Fluid resultant force exerted by the hand [N]; Ftotal: Total resultant force [N] (See Appendix A); Fnormal: The sum of the fluid forces acting on body segments toward directions perpendicular to the segmental long axis, which is proportional to the square of the segmental velocity. [N] (See Appendix A); Ftangent: The sum of the fluid forces acting on body segments along the direction parallel to the segmental long axis, which is proportional to the square of the segmental velocity. [N] (See Appendix A); Faddmass: The sum of the inertial force acting on the body segments due to the acceleration of a mass of water [N] (See Appendix A); Fbuoyant: The sum of the buoyant forces acting on the body segments [N] (See Appendix A); D: Fluid resistive force acting on a swimmer’s body (active drag) [N]; T: Thrust (propulsive) force acting in the swimming direction in reaction to the swimmer’s actions [N]; Thand: Thrust force produced in reaction to the actions of the hand [N]; Tupper_limb: Thrust force produced in reaction to the actions of the upper limbs [N]; Tlower_limb: Thrust force produced in reaction to the actions of the lower limbs [N]; Mbody: Whole-body mass of the swimmer [kg]; SF: Stroke frequency (stroke number per second) [Hz]; SL: Stroke length (distance travelled per stroke) [m]; v: Instantaneous centre of mass velocity of the swimmer [m/s]; : Mean of the instantaneous centre of mass velocities in the swimming direction over the period of the stroke cycle [m/s]; a: Centre of mass acceleration of the swimmer [m/s2]; hand: Mean of the instantaneous magnitudes of hand velocity over a period of time [m/s]; Ẇtot: Total mechanical power [W]; Ẇext: External mechanical power [W]; Ẇd: Drag power (mechanical power needed to overcome drag) [W, Nm/s]; α: Angle of attack of the palm plane with respect to the velocity vector of the hand [deg]; ηo: Overall efficiency [%]; ηp: Propelling efficiency [%]; MAD-system: Measuring Active Drag system; MRT method: Measuring Residual Thrust method.
29 September 2020 in Sports Biomechanics
This study aimed to assess kinematic and kinetic changes in front crawl with various stroke frequency (SF) conditions to investigate why swimming velocity (SV) does not increase above a certain SF (SFmax). Eight male swimmers performed 20 m front crawl four times. The first trial involved maximal effort, whereas SF was controlled during the next three trials. The instructed SFs were 100 (T100%), 110 (T110%), and 120% (T120%) of the SFmax. Through pressure measurement and underwater motion analysis, hand propulsive force (calculated by the difference between the palm and dorsal pressure value and the hand area) and the angle of attack of the hand were quantified, and differences between trials were assessed by a repeated-measures ANOVA. There was no difference in SV between the conditions, while the angle of attack during the latter half of the underwater stroke at T120% was smaller by 25.7% compared with T100% (p = 0.007). The lower angle of attack induced a lower pressure value on the palm that consequently caused a smaller hand propulsive force at T120% than T100% (p = 0.026). Therefore, the decrease in the angle of attack must be minimised to maintain the hand propulsive force.
15 February 2022 in Frontiers in Sports and Active Living
Purpose: This study investigated the relationship between hand kinematics, hand hydrodynamic pressure distribution and hand propulsive force when swimming the front crawl with maximum effort.Methods: Twenty-four male swimmers participated in the study, and the competition levels ranged from regional to national finals. The trials consisted of three 20 m front crawl swims with apnea and maximal effort, one of which was selected for analysis. Six small pressure sensors were attached to each hand to measure the hydrodynamic pressure distribution in the hands, 15 motion capture cameras were placed in the water to obtain the actual coordinates of the hands.Results: Mean swimming velocity was positively correlated with hand speed (r = 0.881), propulsive force (r = 0.751) and pressure force (r = 0.687). Pressure on the dorsum of the hand showed very high and high negative correlations with hand speed (r = −0.720), propulsive force (r = −0.656) and mean swimming velocity (r = −0.676). On the contrary, palm pressure did not correlate with hand speed and mean swimming velocity. Still, it showed positive correlations with propulsive force (r = 0.512), pressure force (r = 0.736) and angle of attack (r = 0.471). Comparing the absolute values of the mean pressure on the palm and the dorsum of the hand, the mean pressure on the dorsum was significantly higher and had a larger effect size (d = 3.71).Conclusion: It is suggested that higher hand speed resulted in a more significant decrease in dorsum pressure (absolute value greater than palm pressure), increasing the hand propulsive force and improving mean swimming velocity.
11 November 2024 in Sports Biomechanics
This study aimed to investigate the effect of the flutter kick on the propulsive force generated by a stroke. Eight male swimmers performed 20 m front crawl trials under two conditions: the Whole Condition, involving maximum effort (T100%) and stroke frequencies at 70, 80, and 90% of T100%, and the Arm Condition, which excluded the flutter kick and matched stroke frequencies with the Whole Condition. Various parameters, including swimming velocity, stroke frequency, stroke length, three-dimensional (3D) resultant hand speed, and hand propulsion were calculated based on underwater 3D motion analysis and hand pressure distribution measurements. A two-way repeated-measures ANOVA was conducted to assess differences, considering the conditions and instructed frequencies as the two factors. There was no significant interaction between the condition and intensity for any of the variables. There was a significant main effect of condition on swimming velocity and stroke length, with these variables being 16.9-18.5% higher and 17.3-19.5% longer, respectively, in the Whole Condition compared to the Arm Condition. However, there was no difference in hand propulsion between the conditions, and it was clarified that the flutter kick did not affect hand propulsion at any swimming velocity.
6 May 2024 in Sports Biomechanics
This study aimed to elucidate the foot kinematics and foot pressure difference characteristics of faster swimmers in undulatory underwater swimming (UUS). In total, eight faster and eight slower swimmers performed UUS in a water flume at a flow velocity set at 80% of the maximal effort swimming velocity. The toe velocity and foot angle of attack were measured using a motion capture system. A total of eight small pressure sensors were attached to the surface of the left foot to calculate the pressure difference between the plantar and dorsal sides of the foot. Differences in the mean values of each variable between the groups were analysed. Compared to the slower swimmers, the faster swimmers exhibited a significantly higher swimming velocity (1.53 ± 0.06 m/s vs. 1.31 ± 0.08 m/s) and a larger mean pressure difference in the phase from the start of the up-kick until the toe moved forward relative to the body (3.88 ± 0.65 kPa vs. 2.66 ± 1.19 kPa). The faster group showed higher toe vertical velocity and toe direction of movement, switching from lateral to medial at the time of generating the larger foot pressure difference in the up-kick, providing insight into the reasons behind the foot kinematics of high UUS performance swimmers.
6 November 2025 in Computer Methods in Biomechanics and Biomedical Engineering
This study aimed to simplify swimming simulation workflow using motion capture data and evaluate the resemblance of fluid force estimated from simulation and pressure distribution. Marker coordinate was collected during swimming using a motion capture system, while small pressure sensors attached to the hand and foot measured pressure distribution. The simulation used the coordinate data to reproduce relative swimming motions, with absolute angles of body segments input to calculate fluid force. The simplified workflow reduced the number of required inputs and demonstrated close resemblance in the temporal changes of hand and foot fluid force between actual swimming and the simulation.