High temperature resistant structural Cr-Mo and Cr-Mo-V steels have existed for more than a century and have been used with great success in the energy and chemical industries. Typical products for these industries are boilers, heaters, heat exchangers, reactors, gas turbines, hydrocrackers, high pressure vessels, etc. For welding such steels in an environment of protective gases and under a flux using a welding wire diam. 1.2–3.0 mm from low-carbon Cr-Mo-V steels, typical representatives of which include CrMoV1Si or Sv-08KhGSMFA and their analogues and modifications. A separate area of use of this wire is the recovery and repair of parts operating under conditions of abrasive wear by the surfacing method. In addition, this wire has prospects for successful application in wire-arc additive manufacturing technologies (3D printing). For the production of such a wire, as a metallurgical billet, is using the wire rod of diameter 5.5 mm, which, along with other consumer properties, should have high manufacturability during deep cold deformation by drawing by modern high-performance equipment. According to the results of the analysis of scientific and technical sources, the work summarizes the modern trends and problems in the production of low-carbon Cr-Mo-V steel wire rod and wire for welding purposes, a number of issues regarding the current requirements of regulatory documentation and specifications of the best global and domestic manufacturers of alloyed steels wire rod are considered, and the main target indicators of the quality of the corresponding metal products are determined, taking into account the characteristics of the welding materials themselves. In order to successfully solve the urgent problem of increasing the deformability of products made of low-carbon Cr-Mo-V steels for welding purposes, a set of scientific and practical tasks has been defined, the solution of which will significantly supplement the database of previously obtained results with new knowledge about the influence of the alloying system on the course of phase-structural transformations and complex of mechanical properties of wire rod. The results of the relevant research will form the basis for the creation of new technological solutions for the controlled management of the structure formation processes of the studied steels and will ensure the production of welding materials at reduced material costs, the production of which is currently absent in Ukraine.