1 May 2006 in Corrosion Science
The present paper focuses on the observed corrosion-induced embrittlement of alloy 2024 and tries to answer the key question on whether the observed embrittlement is attributed to hydrogen uptake and trapping in the material. Hydrogen is produced during the corrosion process and is being trapped in distinct energy states, which correspond to different microstructural sites. The formation of a hydrogen-affected zone beneath the corrosion layer is supported by fractographic analysis. Removal of the corrosion layer leads to complete restoration of yield strength but only partial restoration of ductility. Additional heat treatment to release the trapped hydrogen leads only to complete restoration of ductility. (c) 2005 Elsevier Ltd. All rights reserved
9 April 2002 in Journal of Fluid Mechanics
Experimental results are reported on the structure of gravity-driven film flow along an inclined periodic wall with rectangular corrugations. A fluorescence imaging method is used to capture the evolution of film height in space and time with accuracy of a few microns. The steady flow is found to exhibit a statically deformed free surface, as predicted by previous asymptotic and numerical studies. Though usually unstable, its characteristics determine much of the subsequent non-stationary dynamics. Travelling disturbances are observed to evolve into solitary multi-peaked humps, and pronounced differences from the respective phenomena along a flat wall are noted. Finally, a remarkable stabilization of the flow at high Reynolds numbers is documented, which proceeds through the development of a three-dimensional flow structure and leads to a temporary decrease in film thickness and recession of solitary waves.
1 May 2002 in International Journal of Multiphase Flow
1 June 1997 in Journal of Molecular Catalysis A: Chemical
1 March 2002 in Physics of Fluids
The downstream evolution of disturbances, introduced at the inlet of a liquid film flowing along an inclined plane wall, is studied numerically by solving the full, time-dependent Navier–Stokes equation. Computational results are validated against the predictions of spatial linear stability analysis and against detailed data of the entire evolution process. The structure of the flow field below the waves is analyzed, and the results are used to test assumptions frequently invoked in the theoretical study of film flow by long-wave equations. An interesting prediction is that solitary waves exhibit strongly nonparabolic velocity profiles in front of the main hump, including a slim region of backflow. The computational scheme is subsequently used to study solitary wave interactions. It is predicted that coalescence (the inelastic collision of two humps) is not inevitable but occurs only when the waves differ appreciably in height. Waves of similar size repel monotonically, whereas for intermediate differences in height a strong oscillatory interaction between the two humps is predicted. Encouraging qualitative agreement with the limited experimental information available is noted.
1 January 2006 in Physics of Fluids
Gravity-driven film flow along an inclined periodic wall with transverse rectangular corrugations is studied experimentally. The effect of corrugation steepness (=height∕length) is considered in detail and an interesting contrast emerges between properties of the flow that are apparently independent of corrugation steepness and properties that are strongly affected by it. The steady interaction between the wall and the flow leads to a statically deformed free surface, whose amplitude is independent of the corrugation heights tested. Beyond the maximum steady free-surface amplitude, a three-dimensional pattern is established (consisting of transverse arrays of depressions along corrugation valleys), again at conditions independent of corrugation height. On the contrary, steep corrugations expand significantly the stable region of steady flow. Also, fully developed traveling waves (emerging from ambient noise under unsteady conditions) are significantly larger and more regular than under the same conditions along a flat wall. This difference is attributed to the continuous interaction of traveling pulses with the steadily deformed substrate.