1 December 1993 in Coastal Engineering
1 March 1982 in Journal of Fluid Mechanics
This paper describes an experimental programme carried out in a laboratory channel with rough and smooth beds, to investigate the interaction between gravity waves and a turbulent current. In particular, changes induced in the mean-velocity profiles, turbulent fluctuations, bed shear stresses and wave attenuation rates are considered for a range of wave heights, keeping the wave period constant. The smooth-boundary tests were carried out as a necessary preliminary to the more-realistic rough-boundary condition.A directionally sensitive laser anemometer was used to measure horizontal, vertical, and 45° velocity components in the oscillating fluid, and an on-line minicomputer was programmed to produce ensemble averages of velocities, Reynolds stresses and wave-elevation data. The cycle was sampled at 200 separate phase positions, with 180 observations at each position. Measurements were made at up to 30 points in the vertical.Preliminary tests were carried out on the unidirectional current and on the waves alone. These show that mean-velocity profiles and turbulence parameters of the current agree satisfactorily with previous experiments, and that the waves are approximated closely by Stokes’ second-order theory.For combined wave and current tests, mean-velocity profiles are generally found to differ from those suggested by a linear superposition of wave and current velocities, a change in boundary-layer thickness being indicated. However, shear stresses at the smooth boundary are found to be described by such a linear addition.
1 May 1983 in Journal of Fluid Mechanics
The results of an experimental study of the interaction between waves and a current propagating in the same direction, have been reported by Kemp & Simons (1982). This paper describes the second part of the study, and considers the case of waves propagating against the current. Tests were performed in a laboratory flume with smooth and rough beds, and velocity measurements were made with a directionally sensitive laser anemometer as described in the previous paper. Analysis, including ensemble averaging of velocities and surface elevation, was performed by an on-line computer. Results indicate that the rate of wave attenuation is greatly increased by the addition of an opposing current, and reduced by a following current. Wave profiles remain closely described by Stokes second-order theory; orbital velocities are also found to be in agreement with a second-order wave theory modified to take account of the presence of the current. Certain results described occur regardless of the relative directions of current and wave. Mean velocities in the upper flow increase in the direction of the wave generator for increasing wave height. This suggests that the current is enhancing the wave-induced mass transport. Near the bed the velocity profiles so change that above the rough bed the current is retarded by the wave motion. In the logarithmic layer over the smooth bed velocities are increased with increasing wave height. However, all changes to velocity profiles have to be carefully interpreted, as the sidewall boundary layer decreases in thickness with even the smallest wave superimposed on the current. Turbulence intensities and Reynolds stresses near the rough bed are increased by the presence of the waves, most strongly in a layer two roughness heights above bed level, where fluctuations are periodic and effected by vortices ejected from the roughness troughs. Above this level, and over the smooth bed, turbulence levels are similar to those for the currents alone.
1 January 2022 in Ocean Engineering
9 February 2023 in Soil Dynamics and Earthquake Engineering
1 October 2017 in Coastal Engineering