Zheda Li

Zheda Li

Auto-generated profile, based on publicly available information

Zheda Li

Department of Electrical Engineering, University of Southern California, Los Angeles, CA, USA

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 February 2018 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
ZLZheda Li
Zheda Li
SHShengqian Han
Shengqian Han
SSSeun Sangodoyin
Seun Sangodoyin
RWRui Wang
Rui Wang
AMAndreas F. Molisch
Andreas F. Molisch
Considering the design of two-stage beamformers for the downlink of multi-user massive multiple-input multiple-output systems in frequency division duplexing mode, this paper investigates the case where both the link ends are equipped with hybrid digital/analog beamforming structures. A virtual sectorization is realized by channel-statistics-based user grouping and analog beamforming, where the user equipment only needs to feedback its intra-group effective channel, and the overall cost of channel state information (CSI) acquisition is significantly reduced. Under the Kronecker channel model assumption, we first show that the strongest eigenbeams of the receive correlation matrix form the optimal analog combiner to maximize the intra-group signal to inter-group interference plus noise ratio. Then, with the partial knowledge of instantaneous CSI, we jointly optimize the digital precoder and combiner by maximizing a lower bound of the conditional average net sum rate. Simulations over the propagation channels obtained from geometric-based stochastic models, ray tracing results, and measured outdoor channels, demonstrate that our proposed beamforming strategy outperforms the state-of-the-art methods.

24 April 2017 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Open access
ZLZheda Li
Zheda Li
SHShengqian Han
Shengqian Han
AMAndreas F. Molisch
Andreas F. Molisch
In this paper, we consider the design of analog beamformers for the downlink of multi-user massive multiple-input-multiple-output (MIMO) systems. We specifically investigate systems, where both link ends are equipped with hybrid digital/analog beamforming structures, where the analog beamformers are adapted based on second order channel statistics, reducing the training overhead as well as hardware effort. We present a framework for the optimization of such beamformers operating in mm-wave channels, exploiting the directional characteristics and sparse nature of such channels. We develop an approximate upper bound of the ergodic sum capacity, based on which efficient beamforming algorithms are devised. Simulation results show significant performance improvements of the proposed algorithms compared with the state-of-the-art algorithms.

1 May 2016
Verified
Conference Paper
Closed access
ZLZheda Li
Zheda Li
SHShengqian Han
Shengqian Han
AMAndreas F. Molisch
Andreas F. Molisch
In this paper, we consider the design of two-stage beamformers for the downlink of multi-user frequency-division-duplexing (FDD) massive multiple-input multiple-output (MIMO) systems. We consider the case that both link ends are equipped with hybrid analog/digital (HDA) beamforming structures. With analog beamforming and user grouping based on the second-order channel statistics, the user equipment (UE) only needs to feed back its intra-group effective channel. We first show that the strongest eigenbeams of the receive correlation matrix form the optimal analog combiner under the Kronecker channel model assumption. Then, with limited instantaneous channel state information, we jointly optimize the digital precoder and combiner for conditional average net sum-rate maximization by maximizing its lower bound. To initialize our algorithm efficiently, we present a digital precoder design to maximize the conditional average signal-to-leakage-plus-noise ratio (SLNR). Simulation results show significant performance improvements compared to state-of-the-art algorithms.

5 February 2020 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
RWRui Wang
Rui Wang
CBCelalettin Umit Bas
Celalettin Umit Bas
ZCZihang Cheng
Zihang Cheng
TCThomas Choi
Thomas Choi
HFHao Feng
Hao Feng
AMAndreas F. Molisch
Andreas F. Molisch
This paper investigates the capability of millimeter-wave (mmWave) channel sounders with phased arrays to perform super-resolution parameter estimation, i.e., determine the parameters of multipath components (MPC), such as direction of arrival and delay, with resolution better than the Fourier resolution of the setup. We analyze the question both generally, and with respect to a particular novel multi-beam mmWave channel sounder that is capable of performing multiple-input-multiple-output (MIMO) measurements in dynamic environments. We firstly propose a novel two-step calibration procedure that provides higher-accuracy calibration data that are required for Rimax or SAGE. Secondly, we investigate the impact of center misalignment and residual phase noise on the performance of the parameter estimator. Finally we experimentally verify the calibration results and demonstrate the capability of our sounder to perform super-resolution parameter estimation.

1 April 2013
Verified
Conference Paper
Closed access
RHRuisi He
Ruisi He
AMAndreas F. Molisch
Andreas F. Molisch
ZZZhangdui Zhong
Zhangdui Zhong
BABo Ai
Bo Ai
JDJianwen Ding
Jianwen Ding
ZLZheda Li
Zheda Li
The high-speed railway propagation channel has significant effect on the design and performance analysis of wireless railway control systems. An important feature of the high-speed railway communications is the usage of directional transmitting antennas, due to which the receiver may experience strong attenuation of the line-of-sight (LOS) path under the base station (BS). This leads to a drop, and strong variations, of the signal strength under the BS. While the physical origin of the signal variations is different from conventional shadowing, it can be described by similar statistical methods. However, the effect has been largely neglected in the literature. In this paper we first define the region of the bottom of the BS, and then present a simple shadow fading model based on the measurements performed in high-speed railways at 930 MHz. It is found that the bottom area of the BS has a range of 400 m – 800 m; the standard deviation of the shadowing also follows a Gaussian distribution; the double exponential model fits the autocovariance of the shadow fading very well. We find that the directivity of the transmitting antenna leads to a higher standard deviation of shadowing and a smaller decorrelation distance under the BS compared to the region away from the BS.

3 November 2017 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Open access
ZLZheda Li
Zheda Li
SHShengqian Han
Shengqian Han
AMAndreas F. Molisch
Andreas F. Molisch
The high training cost of massive multiple-input multiple-output (MIMO) systems motivates the use of hybrid digital/ analog (HDA) beamforming structures. This paper considers the joint design of analog beamformers when both link ends of a millimeter (mm)-wave massive MIMO system are equipped with such HDA structures. We aim to maximize the multi-user (MU) MIMO net average throughput of the downlink in an Frequency Division Duplex (FDD) system. To achieve this, we develop an optimization framework, namely user-centric virtual sectorization (UCVS), to explore the tradeoff of training overhead, beamforming gain, and spatial multiplexing gain. In the UCVS, both the channel-statistics-based analog beamforming design and a non-orthogonal donwlink training scheme are investigated to reduce the necessary cost of instantaneous channel acquisition. By maximizing an approximate net average throughput, we devise efficient algorithms to realize the suboptimal UCVS. With generic mm-wave channel models, we demonstrate by simulations that our proposed scheme outperforms state-of-the-art methods in various typical scenarios of mm-wave communications.