Material elastic moduli are used to assess stiffness, elastic response, strength, and residual life. Ultrasound (US) measurements of propagation wave speeds (for longitudinal and shear waves) are now primary tools for non-destructive evaluation (NDE) of elastic moduli. Most US techniques measure the time-of-flight of through-transmission signals or reflected signals from the back wall. In both cases, an independently determined sample thickness is required. However, US methods are difficult for complex (non-flat) samples. When the local thickness is unknown, the propagation speed cannot be determined. On the other hand, the propagation speed of Rayleigh waves can be calculated without knowledge of sample thickness, but another independent measurement is still required to compute both Young's modulus and Poisson's ratio. We present a comprehensive theoretical background, numerical simulations, and experimental results that clearly show that when the material density is assumed known, both elastic constants of an isotropic metal sample can be determined with laser-ultrasound by tracking two types of surface propagating waves without any sample contact (both signal excitation and detection are performed optically). In addition to a conventional surface, or Rayleigh, acoustic wave, a leaky surface wave can also be launched with nanosecond laser pulses in the thermoelastic regime of excitation (i.e., without material ablation) close to the source that propagates along the sample surface with speed close to that of bulk longitudinal waves. Samples can be of arbitrary shape and their thickness need not be measured.
10 October 2024 in IEEE Transactions on Dielectrics and Electrical Insulation
Due to their high strength-to-weight ratio and good dielectric properties fiber-reinforced polymers have gained significant interest in different industrial fields, including the automotive, aerospace, and energy sectors. Despite this attention, the evaluation of the properties of polymer-based composite components, both as part of post-manufacturing control and in-service checks, remains challenging. In this article, ultrasonic testing is investigated as a nondestructive approach for the quality evaluation of high-voltage composite insulators. Classical phase array ultrasonic testing is compared with the total focusing method. The results are validated using computed tomography and a destructive testing approach. It was demonstrated that the proposed ultrasonic testing (UT) technique detected microcracks and small voids in the analyzed samples similar to the reference testing approaches. It was also proved that the water immersion total focusing method can be successfully implemented in a full-scale production process if the scanning and data analysis tasks are properly automated. Since the pilot solution was developed to evaluate objects with relatively simple shapes, further work is needed to cope with more complex geometries.
Recent years have brought more attention to new damage detection approaches based on nonlinear phenomena associated with Shear Horizontal (SH) waves. Many nonlinear effects–previously observed in ultrasonic wave propagation–have been considered for structural damage detection. The major effort has been put on classical nonlinear effects, such as higher harmonic generation. More recently, nonlinear vibro-acoustic modulation and modulation transfer mechanisms have been also observed in SH wave propagation. However, these phenomena have not been used for structural damage detection. The paper attempts to fulfill this gap. The proposed method involves two excitation waves. The low-frequency pumping wave is used for damage perturbation. In addition, high-frequency SH wave is used as a probing wave. The probing wave is modulated by the pumping wave in the presence of structural damage. The method is used in the paper for fatigue crack detection in metallic structural components. The results demonstrate that the proposed approach has a potential for structural damage detection. Previous research work demonstrates that classical nonlinear effects (e.g., higher harmonic generation) observed in SH waves offer better sensitivity to material microdefects than similar effects observed in longitudinal wave propagation. Therefore, it is anticipated that non-classical nonlinear affects associated with SH wave propagation will show similar potential. However, more research work is needed to confirm this assumption.