This study presents an experimental investigation and thermodynamic 0D modeling of the combustion of a compression-ignition engine, fueled by an alternative fuel based on neem biodiesel (B100) as well as conventional diesel (D100). The study highlights the effects of the engine load at 50%, 75% and 100% and the influence of the heat loss models proposed by Woschni, Eichelberg and Hohenberg on the variation in the cylinder pressure. The study shows that the heat loss through the cylinder wall is more pronounced during diffusion combustion regardless of the nature of the fuels tested and the load range required. The cylinder pressures when using B100 estimated at 89 bars are relatively higher than when using D100, about 3.3% greater under the same experimental conditions. It is also observed that the problem of the high pressure associated with the use of biodiesels in engines can be solved by optimizing the ignition delay. The net heat release rate remains roughly the same when using D100 and B100 at 100% load. At low loads, the D100 heat release rate is higher than B100. The investigation shows how wall heat losses are more pronounced in the diffusion combustion phase, relative to the premix phase, by presenting variations in the curves.
In order to achieve the Sustainable Development Goals (SDGs), it is necessary to quantitatively examine the interactions in the EF2W nexus in more detail. The main objective of this work is to model and quantify the EF2W nexus. The approach and model (input–output model) used from the literature is applied to the case of Cameroon. This model has some advantages that make it special, namely the possibility of establishing quantitative relationships on a local, national, regional, or global scale. The results indicate that the method presented in this study is sufficiently relevant to achieve a quantitative framework for modeling the sixteen (16) relationships intertwining the EF2W. Moreover, the analyses carried out on the EF2W interactions for the three decades (1990–2020) show that the energy sector is strongly impacted by biomass, water, and petroleum products with very low impact of waste; the proportion of energy for electricity generation is, on average, 67.528%; the contribution of water (surface and groundwater, water use per ton of food) for agriculture is estimated to be 0.16%, on average, for 17.44 m3/t feed; the energy sector contributed during the three decades 0.42% for 0.88 toe/kt of energy produced. As for the waste (agricultural and animal waste), their use in the agricultural sector is, on average, 97.80%. These results have a significant impact on the energy mix in the management and distribution of production sources and its uses in the different sectors considered. A new optimal approach should be considered.