13 September 2021 in IEEE Transactions on Wireless Communications
Phased arrays, commonly used in IEEE 802.11ad and 5G radios, are capable of focusing radio frequency signals in a specific direction or a spatial region. Beamforming achieves such directional or spatial concentration of signals and enables phased array-based radios to achieve high data rates. Designing beams for millimeter wave and terahertz communication using massive phased arrays, however, is challenging due to hardware constraints and the wide bandwidth in these systems. For example, beams which are optimal at the center frequency may perform poor in wideband communication systems where the radio frequencies differ substantially from the center frequency. The poor performance in such systems is due to differences in the optimal beamformers corresponding to distinct radio frequencies within the wide bandwidth. Such a mismatch leads to a misfocus effect in near-field systems and the beam squint effect in far-field systems. In this paper, we investigate the misfocus effect and propose InFocus, a low complexity technique to construct beams that are well suited for massive wideband phased arrays. The beams are constructed using a carefully designed frequency modulated waveform in the spatial dimension. InFocus mitigates beam misfocus and beam squint when applied to near-field and far-field systems.
7 April 2021 in IEEE Journal of Selected Topics in Signal Processing
Millimeter-wave (mmWave) joint communication-radar (JCR) will enable high data rate communication and high-resolution radar sensing for applications such as autonomous driving. Prior JCR systems that are based on the mmWave communications hardware, however, suffer from a limited angular field-of-view and low estimation accuracy for radars due to the employed directional communication beam. In this paper, we propose an adaptive and fast combined waveform-beamforming design for the mmWave automotive JCR with a phased-array architecture that permits a trade-off between communication and radar performances. To rapidly estimate the mmWave automotive radar channel in the Doppler-angle domain with a wide field-of-view, our JCR design employs circulant shifts of the transmit beamformer to acquire radar channel measurements and uses two-dimensional compressed sensing (CS) in the space-time dimension. We optimize these circulant shifts to minimize the coherence of the CS matrix, under the space-time sampling constraints in our problem. We evaluate the JCR performance trade-offs using a normalized mean square error (MSE) metric for radar estimation and a distortion MSE metric for data communication, which is analogous to the distortion metric in the rate-distortion theory. Additionally, we develop a MSE-based weighted average optimization problem for the adaptive JCR combined waveform-beamforming design. Numerical results demonstrate that our proposed JCR design enables the estimation of short- and medium-range radar channels in the Doppler-angle domain with a low normalized MSE, at the expense of a small degradation in the communication distortion MSE.
16 April 2019 in IEEE Transactions on Wireless Communications
Channel estimation at millimeter wave (mmWave) carrier frequencies is challenging when large antenna arrays are used. Prior work has leveraged the sparse nature of mmWave channels via compressed sensing-based algorithms for channel estimation. Most of these algorithms, though, assume perfect synchronization and are vulnerable to phase errors that arise due to carrier frequency offset and phase noise. Recently, sparsity-aware, non-coherent beamforming algorithms that are robust to phase errors were proposed for narrowband phased array systems with full resolution analog-to-digital converters. Such energy-based algorithms, however, are not robust to heavy quantization at the receiver. In this paper, we develop a joint carrier frequency offset and wideband channel estimation algorithm that is scalable across different hardware architectures. Our method exploits the sparse nature of mmWave channels in the angle-delay domain, in addition to the compressibility of the phase error vector. We formulate the joint estimation as a quantized sparse bilinear optimization problem and then use message passing for recovery. We also give an efficient implementation of a generalized bilinear message passing algorithm for the joint estimation in one-bit receivers. Simulation results show that our method is able to estimate the frequency offset and the channel compressibility, even in the presence of phase noise.
16 September 2019 in IEEE Transactions on Communications
Millimeter wave (mmWave) systems can enable high data rates if the link between the transmitting and receiving radios is configured properly. Fast configuration of mmWave links, however, is challenging due to the use of large antenna arrays and hardware constraints. For example, a large amount of training overhead is incurred by exhaustive search-based beam alignment in typical mmWave phased arrays. In this paper, we present a framework called FALP for Fast beam Alignment with Low-resolution Phase shifters. FALP uses an efficient set of antenna weight vectors to acquire channel measurements, and allows faster beam alignment when compared to exhaustive scan. The antenna weight vectors in FALP can be realized in ultralow power phase shifters whose resolution can be as low as onebit. From a compressed sensing (CS) perspective, the CS matrix designed in FALP satisfies the restricted isometry property and allows CS algorithms to exploit the fast Fourier transform. The proposed framework also establishes a new connection between channel acquisition in phased arrays and magnetic resonance imaging.
10 December 2018 in IEEE Transactions on Signal Processing
Next generation wireless networks will exploit the large amount of spectrum available at millimeter wave (mmWave) frequencies. Design of mmWave systems, however, is challenging due to strict power, cost and hardware constraints at higher bandwidths. To achieve a good SNR for communication, mmWave systems use large antenna arrays. Beamforming with highly directional beams is one way to use the antennas. As the channel changes over time, the beams that maximize the SNR have to be estimated quickly to reduce the training overhead. Prior work has exploited the observation that mmWave channels are sparse to perform compressed sensing (CS) based beam alignment with few channel measurements. Most of the existing CS-based algorithms, however, assume perfect synchronization and fail in the presence of carrier frequency offset (CFO). This paper presents Swift-Link, a fast beam alignment algorithm that is robust against the offset. Swift-Link includes a novel randomized beam training sequence that minimizes the beam alignment errors due to CFO and a low-complexity algorithm that corrects these errors. Even with strict hardware constraints, our algorithm uses fewer channel measurements than comparable CS algorithms and has analytical guarantees. Swift-Link requires a small output dynamic range at the analog-to-digital converter compared to beam-scanning techniques.
8 January 2021 in IEEE Transactions on Wireless Communications
Millimeter wave (mmWave) communication is one viable solution to support Gbps sensor data sharing in vehicular networks. The use of large antenna arrays at mmWave and high mobility in vehicular communication make it challenging to design fast beam alignment solutions. In this paper, we propose a novel framework that learns the channel angle-of-departure (AoD) statistics at a base station (BS) and uses this information to efficiently acquire channel measurements. Our framework integrates online learning for compressive sensing (CS) codebook learning and the optimized codebook is used for CS-based beam alignment. We formulate a CS matrix optimization problem based on the AoD statistics available at the BS. Furthermore, based on the CS channel measurements, we develop techniques to update and learn such channel AoD statistics at the BS. We use the upper confidence bound (UCB) algorithm to learn the AoD statistics and the CS matrix. Numerical results show that the CS matrix in the proposed framework provides faster beam alignment than standard CS matrix designs. Simulation results indicate that the proposed beam training technique can reduce overhead by 80% compared to exhaustive beam search, and 70% compared to standard CS solutions that do not exploit any AoD statistics.