This work reports the impact of gamma-ray (γ-ray) irradiation-induced degradation based on the trap behaviors in amorphous indium-gallium-zinc-oxide (a-IGZO) thin-film transistors. By employing multiple measurement configurations via low-frequency noise and direct current I–V characterization, we quantitatively investigated the energetic distribution of subgap density-of-states in the a-IGZO channel and the spatial distribution of oxide traps (Not) in the gate insulator, respectively. Also, the qualitative analysis was performed to determine the oxygen-related defects after γ-ray irradiation using x-ray photoelectron spectroscopy. Furthermore, the validity of our results was additionally confirmed by measuring the breakdown voltage and applying positive-bias stress to the fabricated devices exposed to radiation for accelerated tests.
The trap behavior in a two-dimensional (2D) ferroelectric semiconductor (FeS) field-effect transistors (FETs) that can overcome the device scaling limit of conventional ferroelectric FETs was analyzed. The conventional ferroelectric FETs exhibit a counterclockwise hysteresis loop, whereas ferroelectric channel-based FETs with high effective oxide thickness exhibit a clockwise hysteresis loop. Therefore, it is challenging to determine the contribution of ferroelectric polarization switching and trap states to the current conduction of FeS-FETs and to quantify their respective impacts, owing to their complex interaction. The modified conductance method with a four-element equivalent circuit model was employed to analyze the behavior of intrinsic trap states, with parasitic capacitance de-embedded, depending on the FeS polarization switching states. As a result, we confirmed that over the full energy range trap density can be extracted by unique characteristics of FeS-FETs. The retention characteristic was maintained at over 70 % of the initial memory on/off ratio when extrapolated to 104 s. Based on these results, guidelines for undefined trap state behavior of 2D α-In2Se3 FeS-FETs were presented.
This work reports an effective technique that is proposed for the simultaneous extraction of the energy distribution of donor- and acceptor-like interface trap states [Dit,D(E) and Dit,A(E)] over a wide range of bandgap energies using a single current–voltage (I–V) measurement in vertically stacked silicon nanowire (Si-NW) gate-all-around field-effect transistors. In the proposed method, we analyzed Dit,D(E) and Dit,A(E) based on the trap-induced photoresponsive gate-induced drain leakage with sub-bandgap optical source (Eph = hν < Eg) at VGS ≪ VFB and differential body factor technique in the subthreshold current at VFB < VGS < VT, respectively.
In this study, we fabricated thin-film transistors by depositing Cu2O through plasma-enhanced atomic layer deposition (3.6 k cycles), which has the advantages of enhanced chemical reactivity and improved crystal structure of thin films compared to conventional atomic layer deposition. We analyzed traps near the valence band using multi-wavelength light that extended up to the above bandgap, in conjunction with dark-state measured data. Using multi-wavelength light, we extracted traps dependent on the gate voltage. Traps with underestimated density due to limited detectability within the bandgap, dependent on the energy levels of the wavelengths, are filled with photons to extract the captured traps (holes). Our results reveal that the energy-dependent density peaks of VCu and VO, which strongly influence the p-type conduction mechanism, were observed in the trap density near the Fermi level using multiwavelength I–V photo-response. This study reports photo-responsive I–V measurements in aggressively scaled devices, crucial for instability and reliability assessments. Furthermore, trap extraction plays a critical role in the effective integration of n-type oxide semiconductors into CMOS technology, providing valuable insights into the performance analysis of applications.