1 April 2021 in International Journal of Heat and Mass Transfer
29 June 2020 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Optimization of liquid-cooled heatsinks (cold plates) is of critical importance due to their wide-spread application in high-performance electronic packages consisting of heterogeneous integrated systems, field programmable gate arrays (FPGAs), and on-chip hotspots. In this study, the thermo-hydraulic performance of a commercial microchannel impingement cold plate is analyzed in detail. Impingement cold plates are preferred over parallel flow cold plates due to their lower pressure drop where there is no restriction on space (i.e. where flow can enter perpendicular to the electronic board.). Splitting the flow into two branches cuts the flow rate and path in half, which leads to a lower pressure drop through the channels. Since the fins of the present commercial cold plate (considered as the baseline design) are tilted, the effect of fin tilt angle on the hydraulic and thermal performance of the cold plate is also studied. Response surface method is used to optimize the geometry of the fins and impinging inlet. The results of optimization show that hydraulic resistance can be reduced by 50% without a remarkable change in thermal resistance. The effect of geometric parameters on the cold plate thermo-hydraulic performance is studied by using the computational fluid dynamics results at response surface method design points. The variation of the cold plate coefficient of performance with the coolant flow rate and inlet temperature is compared for the baseline design and a selected optimal design. Finally, the effect of impinging inlet geometry on the chip temperature profile is also examined.
23 June 2022 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Miniaturization high heat flux of power electronic devices have posed a colossal challenge for adequate thermal management. Conventional air-cooling solutions are inadequate for high-performance electronics. Liquid cooling is an alternative solution due to the higher specific heat and latent heat associated with the coolants. Liquid-cooled cold plates are typically manufactured by different approaches, such as skived, forged, extrusion, and electrical discharge machining. When researchers are facing challenges in creating complex geometries in small spaces, 3-D-printing can be a solution. In this article, a 3-D-printed cold plate was designed and characterized with water coolant. The printed metal fin structures were strong enough to undergo pressure from the fluid flow even at high flow rates and small fin structures. A copper block with the top surface area of 1 in $\times \,\,1$ in was used to mimic a computer chip. Experimental data have good match with a simulation model, which was built using commercial software 6SigmaET. Effects of geometry parameters and operating parameters were investigated. The fin diameter was varied from 0.3 to 0.5 mm and the fin height was maintained at 2 mm. A special manifold was designed to maximize the surface contact area between coolant and metal surface and therefore minimize thermal resistance. The flow rate was varied from 0.75 to 2 L/min and the coolant inlet temperature was varied from 25 °C to 48 °C. It was observed that for the coolant inlet temperature 25 °C and aluminum cold plate, the junction temperature was kept below 63.2 °C at an input power of 350 W and the pressure drop did not exceed 23 Kpa. Effects of metal materials used in 3-D-printing on the thermal performance of the cold plate were also studied in detail.