This paper reports the characterization of disbonds between a steel plate and a lead plate on the surface of the lead using lock-in thermography. Based on the photothermal model, the excitation frequency of the bonding specimen with the steel plate and the lead plate is optimized. A lock-in thermography testing system is established to inspect the specimen. The Fourier transform method is used to process the infrared image sequences. To improve the signal-to-noise ratio (SNR), a fuzzy c-means (FCM) algorithm is used to process the phase matrix. The influence of number of clusters on the processing results is researched, and the optimal value of clusters number is obtained. The shearing phase technique is used to evaluate the size of the disbonds quantitatively. The measurement results of the artificial disbonds in the specimen show good agreement with the actual values. The results prove that FCM is effective in enhancing the SNR of the phase image, which makes it feasible for the quantitative determination of defect size by the shearing phase technique.
Fused-coating based metal additive manufacturing (FCAM) is a newly established direct metal forming process. This method is characterized by deposition metal materials in a crucible and under the driving pressure the molten metal is extruded out from a special designed nozzle. Hence, dense metal parts with different kind of materials can be built on the moving substrate layer by layer. It provides a method to fabricate metal components with lower costs, clean and cheap materials compared with other AM processes. To study the feasibility of this new AM methodology, an experimental system with a molten metal stream generator, a fused-coating nozzle, a process monitor unit, an inert atmosphere protection unit and a temperature measurement unit has been established. In order to determine the proper parameters in the building process, a metal fused-coating heat transfer model analysis and experimental study is performed by using Sn63-37Pb alloy in building three-dimensional components. The process parameters that may affect fabrication are molten and substrate temperature, layer thickness, the substrate-speed, the temperature of substrate, the distance between the nozzle and substrate and the pressure. Microscopy images were used to investigate the metallurgical bonding between layers. The influence of different parameters on the layer thickness and width was studied quantitatively. At last, the optimal parameter was used to fabricate complex metal parts to demonstrate the feasibility of this new technology compared with other AM methods.