Development of highly active photocatalysts is mandatory for more widespread application of this alternative environmental technology. Synthesis of photocatalysts, such as anatase TiO2, with more reactive, non-equilibrium, crystallographic facets is theoretically justified by a more efficient interfacial charge transfer to reactive adsorbed species, increasing quantum efficiency of photocatalyst. Air and vacuum calcinations of protonated trititanate nanotubes lead to their transformation to anatase nanorods. The nanorods synthesized by air calcination demonstrate photo-oxidation of NO gas more than three times superior to the one presented by the benchmark P-25 photocatalyst. This performance has been explained in terms of 50% higher specific surface area and, more importantly, through the predominance of more reactive, non-equilibrium, {001} crystallographic facets of the anatase nanorods. These facets present a high density of undercoordinated Ti cations, which favors adsorption of reactant species, and strained Ti–O–Ti bonds, leading to more efficient photo-oxidation reactions. Reduced Ti species, such as Ti3+, were not observed in the as-obtained nanorods, while reactive adsorbed molecules are scarce on the nanorods obtained through vacuum calcination. Dip-coating of TiO2 anatase nanorods (air calcined) over soda-lime glass plates was used to prepare visible light transparent, superhydrophilic and highly adherent photocatalytic coatings with homogenously distributed nanopores.
The 1-[ N -(methyl)-(3,5-dimethylphenylamino)]methylnaphthalene (chemical formula C 20 H 21 N) was prepared by means of a condensation between alpha-naphthylaldehyde and 3,5-dimethylaniline in anhydrous ethanol to obtain the aldimine (1) which was reduced with NaBH 4 to afford the 1-[ N -(3,5-dimethylphenylamino)]methylnaphtalene (2), and finally, the compound (3) was obtained by N -alkylation reaction of (2) with methyl iodine (CH 3 I) and potassium carbonate (K 2 CO 3 ) in acetone. Final compound (3) was purified by chromatographic column. The XRPD pattern for the new compound, 1-[ N -(methyl)-(3,5-dimethylphenylamino)]methylnaphthalene, was obtained. This compound crystallizes in monoclinic system with space group P 2 1 / a (No. 14) and refined unit-cell parameters a =13.260(4) Å, b =15.495(5) Å, c =7.719(5) Å, β =90.19(6), and V =1586(1) Å 3 .
Las técnicas usadas tradicionalmente para la construcción son evaluadas por normas y métodos de diseño en la ingeniería, las cuales se van actualizando diariamente para optimizar las propiedades estructurales y de los materiales. Sin embargo, el uso de materiales naturales está limitado por no contar con estudios necesarios y técnicas de conservación de los mismos y aún más por no contar con normatividad para su utilización en construcciones civiles, esto se ve reflejado en que las comunidades rurales no hacen uso de los materiales propios de su región para mejoramiento y adecuación de sus viviendas, por ello, en el presente estudio se pretende investigar y dar resultados cuantitativos y cualitativos sobre las fibras de caña brava (gynerium sagittatum), esto con el objetivo de determinar si dichas fibras pueden ser utilizadas y tener aplicaciones en el área de la construcción y mejoramiento de viviendas en el sector rural. En este artículo podrá encontrarse la primera fase del proyecto en la cual se realizaron estudios de caracterización física empleando técnicas de microscopía óptica (MO) y microscopía de barredura electrónica (MEB), así como ensayos de resistencia mecánica de tracción y compresión, mediante los cuales fue posible determinar la resistencia del objeto en estudio