6 May 2020 in Journal of Geophysical Research: Solid Earth
Wave Gradiometry (WG) is a dense array data processing method used to extract seismic velocity and other properties of the earth. In this study, we propose using WG for a plane wave field to measure azimuthal anisotropy by fitting the phase velocities from different back azimuths. We applied this new method to the Temporary Western Sichuan Array and obtained the isotropic and azimuthal anisotropy for period bands centered atT = 20, 40, and 60 s in the southeast Tibetan Plateau. Our results show that the fast orientations of anisotropy are well consistent with the strikes of the fault system and orogenic belt. The weak anisotropic magnitude in the northern part of the south Chuandian subblock and a consistence of fast orientation in boundary fault zone (BFZ) at different periods may be attributed to anisotropic relics associated with the Emeishan Large Igneous Province. Comparing our results with those of previous studies, we found that our anisotropic results are consistent with anisotropic structures measured by the Pms phase in the plateau area, while a systematical angular difference exists in the BFZ, Sichuan Basin, and south Chuandian subblock where high Rayleigh wave phase velocity was observed. The Lijiang‐Xiaojin fault and Longmenshan fault appear to form a deep‐rooted strong boundary at the lithospheric scale, as they serve as a boundary for anisotropic structures, isotropic velocity, and the other three WG parameters.
16 March 2024 in Earth and Planetary Science Letters
3 February 2022 in Geophysical Research Letters
Advances in noise‐based velocity change measurements have revealed anomalies before volcanic eruptions. Still, it is difficult to assign them to a certain depth based on the traditional coda wave method. Here we used volcanic tremor (1–2.5 s) and oceanic noise (3 and 3.5 s) as passive sources to calculate the Rayleigh wave velocity changes associated with the 2018 Kilauea eruption. Our simulation show that the velocity decreased at least by 5% at 1–2 km depth beneath the East Rift zone in the co‐eruption time. Before the eruption, we observed a decrease (1%) at the same depth, whereas, at the depths of 0–1 and 2–8 km, the velocity increased by 0.2%–1%. Combined with microearthquakes, The Global Positioning System data, and numerical simulation, our observations suggest that magma intrusion may open the magma dike at 1–2 km depth but induce higher compressive stress (about 3.6–14.4 MPa) in the surrounding areas.
10 January 2025 in Journal of Geophysical Research: Solid Earth
28 April 2026 in Tectonics
20 September 2023 in Geophysical Research Letters
We would like to thank Wei and Shen (2023, https://doi.org/10.1029/2022GL102596) (W23) for their comments on our recent article on GRL. In their comments, Wei and Shen argued that tremor signal on the right side of the cross‐correlation function (CCF) of PAUD‐STCD is from Kilauea crater, and they suggested that the observed time‐delay after eruption might be attributed to the noise source change and other factors. After checking the data and the code carefully, we recognize that signal on the right side of CCF of PAUD‐STCD may be due to seismicity from the Kilauea crater. However, we demonstrate here that it does not affect our conclusions.