4 September 2025 in IEEE Transactions on Industrial Electronics
The frequency-domain electromagnetic (FDEM) method leverages the skin depth effect to extract subsurface information at varying depths. However, inductive suppression in the transmitter system reduces transmission current at high frequencies, severely degrading the signal-to-noise ratio (SNR) and exploration performance. Traditional impedance matching methods are insufficient due to limited tunability or lack of continuous adjustment. To address these limitations, this article proposes a switch-controlled capacitor impedance matching network (SCCIMN) for adaptive, continuous impedance matching across 1–100 kHz. First, the circuit structure of the SCCIMN is introduced, along with the equivalent principle of SCC. Then, a detailed parameter design scheme is provided to ensure the SCCIMN meets the specified requirements. Next, an adaptive control strategy is proposed, enabling the SCCIMN to achieve continuous automatic adjustment within the designated frequency range. Finally, simulations and experiments validate the proposed approach, demonstrating that SCCIMN effectively enhances the transmission current, with a current enhancement rate exceeding 100% across the entire frequency band, more than doubling the transmission current. Furthermore, the SCCIMN exhibits excellent dynamic performance: Proportional-integral-derivative (PID)-based frequency switching is completed within 50 ms, while a look-up table (LUT) approach enables near-instantaneous switching and stabilization within a single cycle. Comparative experiments with switched-capacitor array impedance matching networks (SCAIMNs) also confirm that the SCCIMN significantly enhances the SNR. Therefore, the proposed SCCIMN holds considerable potential for practical applications of the FDEM method.
1 April 2026 in IEEE Transactions on Industrial Electronics
Frequency-domain electromagnetic method (FDEM) is crucial for near-surface exploration, with a trend toward multifrequency transmission to enhance efficiency. However, the inherent inductive nature of transmitter coils severely attenuates high-frequency signals, limiting shallow imaging capabilities—a challenge that existing multifrequency compensation schemes fail to fully address. To overcome this limitation, this article proposes a novel multifrequency square-wave current transmitter based on a zero-voltage-switching quasi-resonant converter (ZVSQRC). This technique effectively negates the inductive suppression, enabling the transmission of high-fidelity, broadband square-wave currents supporting various waveforms. The article presents the circuit topology, analyzes its operating principle, and provides detailed parameter design guidelines and a control strategy. Simulation and experimental results validate the proposed scheme, demonstrating a maximum operating frequency of 45 kHz under the given parameters. Compared to traditional direct-drive transmitters, the proposed circuit delivers significantly higher current amplitudes above 200 Hz, more than doubling the current at frequencies beyond 700 Hz, with the enhancement effect growing with frequency. Furthermore, it exhibits substantial advantages in both operational bandwidth and current amplitude over conventional triple-frequency resonant (TFR) circuits. This work provides a key enabling technology for developing next-generation, high-efficiency, and broadband FDEM systems.
1 January 2026 in IEEE Sensors Journal