Faculty of Environment, Jan Evangelista Purkyně University in Ústí nad Labem, Pasteurova 3632/15, 40096, Ústí nad Labem, Czech Republic; ORLEN UniCRE a.s, Revoluční 1521/84, 40001, Ústí nad Labem, Czech Republic
Auto-generated profile, based on publicly available information
Jan Snow
Faculty of Environment, Jan Evangelista Purkyně University in Ústí nad Labem, Pasteurova 3632/15, 40096, Ústí nad Labem, Czech Republic; ORLEN UniCRE a.s, Revoluční 1521/84, 40001, Ústí nad Labem, Czech Republic
The production of light olefins, as the critical components in chemical industries, is possible via different technologies. The Fischer–Tropsch to olefin (FTO) process aims to convert syngas to light olefins with high selectivity over a proper catalyst, reduce methane formation, and avoid the production of excess CO2. This review describes the production of light olefins through the FTO process using both unsupported and supported iron-based catalysts. The catalytic properties and performances of both the promoted and bimetallic unsupported catalysts are reviewed. The effect of support and its physico-chemical properties on the catalyst activity are also described. The proper catalyst should have high stability to provide long-term performance without reducing the activity and selectivity towards the desired product. The good dispersion of active metals on the surface, proper porosity, optimized metal-support interaction, a high degree of reducibility, and providing a sufficient active phase for the reaction are important parameters affecting the reaction. The selection of the suitable catalyst with enhanced activity and the optimum process conditions can increase the possibility of the FTO reaction for light-olefins production. The production of light olefins via the FTO process over iron-based catalysts is a promising method, as iron is cheap, shows higher resistance to sulfur, and has a higher WGS activity which can be helpful for the feed gas with a low H2/CO ratio, and also has higher selectivity towards light olefins.
Occurrence, distribution, and toxicity assessment of 16 Polycyclic Aromatic Hydrocarbons (PAHs) prioritized by the US Environmental Protection Agency in pyrolysis products – pyrolysis oil and pyrolysis wax – of different plastics are characterized. PP, HDPE, LDPE, PVC, PS (respectively,...
Pyrolysis represents one of the most convenient technologies for the chemical transformation of waste. The exposure to corrosion products and high temperatures does, however, require chemically resistant construction materials. This study was carried out to analyze the corrosion behavior of 1.4571 (AISI 316Ti) and 1.4305 (AISI 303) stainless steels machined with wire electric discharge machining (WEDM) in a pyrolysis environment. Different machining parameters were used for both materials tested to examine the influence of WEDM machining. The total testing time in the pyrolysis environment was 28 days, with the testing chamber being refilled 12 times. The surface topography was analyzed following the WEDM, cleaning, and corrosion test. The surface morphology and cross-section analyses were carried out using electron microscopy at all three stages of the process. An analysis of the chemical composition of the surfaces was carried out as well as of the pyrolysis environment to which the samples were exposed. It was established that the organic acids found in the pyrolysis chamber did not degrade the tested stainless steels to a meaningful degree. Minor fissures, that is, fine precipitated carbides, were observed on the surface of both the steel types and in their subsurface layer, as well as a significant presence of carbon. This presence was directly connected to the impurities found on the surface after the removal from the test furnace that were probably of a protective or passivation nature.