Crystal structures of ferroelectric materials of stoichiometric and Sr-deficient-and-Bi-excess were refined by neutron powder diffraction. layer and octahedra are considerably distorted and atomic displacements along the a axis cause ferroelectric spontaneous polarization. In both Bi substitution and cation vacancies at the Sr site were revealed and a chemical composition of was obtained. The calculated polarization of is larger than that of the stoichiometric sample, which is consistent with observations of remanent polarization in thin-film capacitors. The Bi substitution and the cation vacancies at the Sr site enhance structural distortion in the octahedra and lead to the larger ferroelectric spontaneous polarization and the higher Curie temperature.
Crystal structures and ferroelectric properties of a series of Bi-layered compounds, and were investigated. The structures of and are orthorhombic, while that of is pseudotetragonal on the macroscopic scale but consists of microdomains with orthorhombic distortion. The ferroelectric Curie temperature of was over 600 °C, and that of was over 300 °C. in contrast, showed relaxor-type ferroelectric behavior; that is, in the plot of temperature dependence of dielectric constant, a broad peak appeared around 60 °C. As the size of the A-site cation decreases from to the lattice mismatch between and planes in the perovskite-type unit of increases and the structural distortion becomes more pronounced. This distortion leads to the higher Curie temperature and the larger spontaneous ferroelectric polarization.
The crystal structures of and were refined by neutron powder diffraction. Large structural distortions were revealed, and ferroelectric polarizations along the and axes were calculated from the displacements of the constituent ions. In La atoms substitute for Bi atoms in a perovskite-type unit only, and the substitution causes less distortion of the structure, resulting in smaller spontaneous polarization and lower ferroelectric Curie temperature. Electronic-structure calculations revealed that covalent interaction, which originates from the strong hybridization between Ti and O orbitals, plays an important role in the structural distortion and ferroelectricity of the materials. Changes in ceramic-sample density with sintering temperature give information concerning device fabrication temperature; that is, substituting La for Bi atoms appears to “increase” the synthesis temperature of the and systems.