26 May 2023 in IEEE/ASME Transactions on Mechatronics
In this article, a grinding robot for large area and an impedance-based force control method applied to the robot are described. With the development of science and technology, the demand for various industrial robots increased, and among them, the demand and importance of grinding robots that require high risk and precision increased. In particular, research on grinding robots targeting large areas has not been conducted relatively, and accordingly, the design and control mechanism of robots specialized in large areas was needed. A robot consisting of a manipulator and a grinding module with a 2-DOF parallel structure is proposed as the design of a new grinding robot. The control method is based on impedance force control mainly used in existing grinding robots, but to overcome the limitations of using only impedance control, the impedance control via model-based prediction optimization (MPO) is proposed as a control technique for grinding robots. Experiments were conducted to verify the force tracking ability of the proposed control, resulting in a 28.1% improvement in settling time for the desired force. Even for disturbance, more improved recovery performance than conventional controllers has been verified. As a result, proposed impedance force control via MPO shows improved force tracking performance over conventional impedance control, and is presented as one of the appropriate control methods for grinding robots targeting large areas.
26 July 2021 in IEEE Access
In this paper, a robust design of a screw wheel is presented, based on the Taguchi method to accelerate a screw-based crawling robot. Screw-based crawling robots have been studied before, but their application is limited because of their limited speed. To solve this problem, robust design is applied for the screw wheel geometry driving on granular surfaces, such as desert sand, which has not been studied before. Each of the four parameters determining the screw wheel geometry and two user conditions were set at three levels, and the Taguchi method was applied through the L 9 (3 4 ) orthogonal array. The experimentally optimized parameters were as follows: the slope angle was 35°, the height of the blade was 14 mm, the number of spirals was one, and the blade had a semicircular cross-section. A verification experiment was conducted with the optimized model to verify the Taguchi method's validity. In conclusion, the robust design using the Taguchi method is suitable for solving the speed problem of a screw-based crawling robot on a granular surface.
6 June 2023 in International Journal of Precision Engineering and Manufacturing