The application of phase change materials (PCM) in the thermal envelope of buildings has proven to be an alternative to reduce energy consumption and to improve thermal comfort conditions. The present work evaluates the thermal behavior of gypsum boards modified with a microencapsulated PCM (mPCM) in a cubic test enclosure, considering the climatic conditions of Santiago de Chile in the September–November period of 2017. The design of the test enclosure was performed considering the minimization of parameters that affect the variation of its inner temperature and favoring the heat flow through the gypsum boards. Experimentally, the results reflect the main effects of the implementation of a mPCM, among which the displacement of the maximum heat load and the decrease in the daily oscillation of the internal temperature of the test enclosure (up to 2 °C) stand out. In addition, the mPCM modified gypsum board was thermally characterized to carry out a thermal simulation of the enclosures using EnergyPlus™. The obtained numerical results agree with those obtained experimentally, including the behavior of the transient heat flux through the gypsum boards. Moreover, it was found that considering a null infiltration rate gives place to unrealistic results, suggesting that this parameter should be controlled.
1 September 2020 in IEEE Latin America Transactions
Electrical Resistance Tomography (ERT) is a technique employed in the industrial environment that reconstructs images formed by the impedance distributions inside a vessel. The method relies on measures from a data acquisition system, responsible to inject a current inside the vessel and measures the voltage on the boundaries, and sequentially an inverse problem solution. This paper introduces a low-cost design of an acquisition system that can obtain 30 images/s with a signal-to-noise ratio of 57.47 dB and a maximum error of 3.79%. It utilizes a simple RMS-to-DC converter demodulation scheme to provide good accessibility to researchers aimed at investigating flow patterns of multiphase flow applications.
Electrical Impedance Tomography (EIT) is a technique that enables the reconstruction of the impedance distributions inside a vessel in a multiphase flow of industrial processes. Such a technique combines a data acquisition (DAQ) system to inject a current and to measure the voltages on the sensors and an inverse problem technique to reconstruct the image properly. This problem is highly ill-conditioned, causing errors to produce instabilities. Therefore, when performing the acquisition, the DAQ system must have adequate accuracy to allow the reconstruction of images with good quality. To avoid these measurement inaccuracies, this paper introduces a methodology that aid in the process of development of low-cost systems. It consists of investigating the errors in the current version of the system. Further, predicting the systematic errors of each subsystem by modeling its frequency response by Simulation Program with Integrated Circuit Emphasis (SPICE). From this information, it is possible to perform critical analysis, aiding design decisions.