17 October 2025 in Results in Engineering
25 September 2017 in Shock and Vibration
In a multiobjective particle swarm optimization algorithm, selection of the global best particle for each particle of the population from a set of Pareto optimal solutions has a significant impact on the convergence and diversity of solutions, especially when optimizing problems with a large number of objectives. In this paper, a new method is introduced for selecting the global best particle, which is minimum distance of point to line multiobjective particle swarm optimization (MDPL-MOPSO). Using the basic concept of minimum distance of point to line and objective, the global best particle among archive members can be selected. Different test functions were used to test and compare MDPL-MOPSO with CD-MOPSO. The result shows that the convergence and diversity of MDPL-MOPSO are relatively better than CD-MOPSO. Finally, the proposed multiobjective particle swarm optimization algorithm is used for the Pareto optimal design of a five-degree-of-freedom vehicle vibration model, which resulted in numerous effective trade-offs among conflicting objectives, including seat acceleration, front tire velocity, rear tire velocity, relative displacement between sprung mass and front tire, and relative displacement between sprung mass and rear tire. The superiority of this work is demonstrated by comparing the obtained results with the literature.
19 July 2025 in Results in Engineering
12 August 2025 in Journal of the Energy Institute
18 April 2026 in SSRN Electronic Journal
To explore hydrogen substitution for reducing carbon emissions from diesel engines, the hydrogen/diesel dual-fuel mode has emerged as a promising solution. This experimental study investigates the effects of hydrogen addition on combustion performance, emission characteristics, and thermal efficiency of a heavy-duty diesel engine operating at low speed (1000 r/min) and high load (up to 60% load). Results show that compared with pure diesel operation, a hydrogen flow rate of 6 L/min reduces soot emissions by 16.5%, increases NOx emissions by 13.5%, raises the peak pressure rise rate (PPRR) to 1.15 MPa/°CA, while maintaining equivalent fuel consumption rate (EFCR) at the same level. However, increased hydrogen substitution leads to higher NOx emissions and PPRR due to intensified heat release. To address these issues, the injection strategy was optimized under different hydrogen substitution levels. Delaying the start of pilot injection (SOIpilot), reducing pilot injection quantity (PIQ), and moderately increasing the EGR ratio gradually decrease NOx emissions and PPRR, albeit with a slight increase in soot emissions. The optimal combination is achieved at a hydrogen flow rate of 6 L/min, SOIpilot of 22°CA BTDC, PIQ of 2.15 g/kW·h, and EGR ratio of 27%, which reduces NOx by 24.71%, increases soot by 3.75%, and lowers PPRR from 1.15 to 1.0 MPa/°CA. These findings not only apply to the tested engine but also provide guidance for designing other hydrogen–diesel dual-fuel engines.