State Key Laboratory of Coordination Chemistry MOE Key Laboratory of High‐Performance Polymer Materials & Technology School of Chemistry Nanjing University Nanjing Jiangsu China
Auto-generated profile, based on publicly available information
Shangshang Chen
State Key Laboratory of Coordination Chemistry MOE Key Laboratory of High‐Performance Polymer Materials & Technology School of Chemistry Nanjing University Nanjing Jiangsu China
Mapping perovskite trap states: The high efficiency of hybrid inorganic-organic perovskite solar cells is mainly limited by defects that trap the charge carriers and lead to unproductive recombination. Ni et al. used drive-level capacitance profiling to map the spatial and energetic distribution of trap states in both polycrystalline and single-crystal perovskite solar cells. The interface trap densities were up to five orders of magnitude higher than the bulk trap densities. Deep traps were mainly located at the interface of perovskites and hole-transport layers, where processing created a high density of nanocrystals. These results should aid efforts aimed at avoiding trap-state formation or passivating such defects. Science , this issue p. 1352
Stability through oxysalts: The stability of organic-inorganic perovskite solar cells is limited by degradation from oxygen and water. Yang et al. show that in situ reaction of perovskites with sulfate or phosphate ions can create thin, strongly bonded lead oxysalt layers that protect defect sites. This layer also boosts charge carrier lifetimes that lead to a power conversion efficiency of more than 20%. Encapsulated devices maintained about 97% of this efficiency with simulated solar irradiation for nearly 2 months at a realistic operation temperature of 65°C. Science , this issue p. 473
Avoiding buried voids: The buried interfaces of perovskite solar cells are difficult to alter after synthesis. During manufacture, Chen et al . removed perovskite films with dimethyl sulfoxide solvent from the hole-transfer layer and observed a substantial void fraction that degraded film performance. Replacing most of the dimethyl sulfoxide with carbohydrazide, a lead-coordinating compound with a much higher boiling point, eliminated voids. Such solar cells maintained high power conversion efficiency after 550 hours of operation at 60°C. —PDS