A qualitative analysis of the various outcomes of a drop impact on solid surfaces with different roughness and wettability is carried out. Water, ethanol, different mixtures of glycerin and water, liquid alloys, and silicone oil were used to provide a wide range of material properties such as surface tension, viscosity, and density. The impact velocity was varied by moving the drop generator vertically with respect to tie plate. Also two drop diameter classes were considered. A variation of roughness amplitude and wavelength was achieved using a laser ablation process on polyvinyl chloride and glass substrates, creating a deterministic microstructure. A highly nonwettable rough surface was prepared with alkylketene dimer (AKD) [1]. A first classification of the different outcomes, in terms of splash, rebound, partial rebound, deposition, and other features, is presented.
In the present work experimental, numerical, and theoretical investigations of a normal drop impact onto a liquid film of finite thickness are presented. The dynamics of drop impact on liquid surfaces, the shape of the cavity, the formation and propagation of a capillary wave in the crater, and the residual film thickness on the rigid wall are determined and analyzed. The shape of the crater within the film and the uprising liquid sheet formed upon the impact are observed using a high-speed video system. The effects of various influencing parameters such as drop impact velocity, liquid film thickness and physical properties of the liquids, including viscosity and surface tension, on the time evolution of the crater formation are investigated. Complementary to experiments the direct numerical simulations of the phenomena are performed using an advanced free-surface capturing model based on a two-fluid formulation of the classical volume-of-fluid (VOF) model in the framework of the finite volume numerical method. In this model an additional convective term is introduced into the transport equation for phase fraction, contributing decisively to a sharper interface resolution. Furthermore, an analytical model for the penetration depth of the crater is developed accounting for the liquid inertia, viscosity, gravity, and surface tension. The model agrees well with the experiments at the early times of penetration far from the wall if the impact velocity is high. Finally, a scaling analysis of the residual film thickness on the wall is conducted demonstrating a good agreement with the numerical predictions.
This paper presents results of an experimental investigation of a single drop impact onto a dry, partially wettable substrate and its numerical simulation. Particularly, the drop spreading diameter and the dynamic contact angle are measured at different time instants after impact. Two surfaces, wax (low wettability) and glass (high wettability), are used to study the effect of surface wettability (static contact angle) on the impact dynamics. It is shown that existing empirical models for the dynamic contact angle (e.g., Hoffman–Voinov–Tanner law) do not predict well the change of the dynamic contact angle, especially at high capillary numbers. In addition to the experimental investigations, the drop impact was studied numerically, focusing primarily on the contact angle treatment. The singularity in the neighborhood of the moving contact line is removed from the computational domain and replaced by a local force with some dependence on the instantaneous advancing/receding contact-line velocity. The predicted time dependence of the drop spreading diameter and of the dynamic contact angle agrees well with the experimental data for both the advancing and receding phases of the impact process.
The flow field around surface-mounted, prismatic obstacles with different spanwise dimensions was investigated using the crystal violet, oil-film and laser-sheet visualization techniques as well as by static pressure measurements. The aim of this study is to highlight the fundamental differences between nominally two-dimensional and fully three-dimensional obstacle flows. All experiments were performed in a fully developed channel flow. The Reynolds number, based on the height of the channel, lay between 8 × 104 and 1.2 × 105. Results show that the middle region of the wake is nominally two-dimensional for width-to-height ratios (W/H) greater than 6. The separated region in front of wider obstacles is characterized by the appearance of a quasi-regular distribution of saddle and nodal points on the forward face of the obstacles. These three-dimensional effects are considered to be inherent to such separating flows with stagnation.