Anthony Fraisse

Anthony Fraisse

Auto-generated profile, based on publicly available information

Anthony Fraisse

Department of Wind Energy, Risø Campus, Technical University of Denmark, Frederiksborgvej 399, 4000 Roskilde, Denmark

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 February 2022 in Energies
Verified
Journal Article
Open access
PDF file
Leon Mishnaevsky Jr.Leon Mishnaevsky Jr.
Leon Mishnaevsky Jr.
NJNicolai Frost-Jensen Johansen
Nicolai Frost-Jensen Johansen
AFAnthony Fraisse
Anthony Fraisse
SFSøren Fæster
Søren Fæster
TJThomas Jensen
Thomas Jensen
BBBrian Bendixen
Brian Bendixen
Maintenance and repair of wind turbines contribute to the higher costs of wind energy. In this paper, various technologies of structural repair of damaged and broken wind turbine blades are compared. The composite plates, mimicking damaged blade parts, were damaged and repaired, using various available curing and bonding technologies. Technologies of repair with hand layup lamination, vacuum repair with hand layup and infusion, ultraviolet repair and high temperature thermal curing were compared. The repaired samples were tested under tensile static and fatigue tests, and subject to microscopic X-ray investigations. It was observed that both the strength of the repaired structures and the porosity depend on the repair technology used. Vacuum-based technologies lead to relatively stiff and lower-strength repaired plates, while ultraviolet-curing technologies lead to average stiffness and high strength. High-temperature vacuum curing leads to the highest maximum stress. Hand layup (both vacuum and without vacuum) leads to high post-repair porosity in the adhesive and scarf, while vacuum infusion leads to low porosity. Fatigue lifetime generally follows the trend of porosity. There exist risks of micro-damaging the parent laminate and the formation of residual stresses in the repaired structure.

1 July 2016 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
AFA Fraisse
A Fraisse
JBJ Beauson
J Beauson
PBP Brøndsted
P Brøndsted
BMB Madsen
B Madsen
The impact of using thermally recycled glass fibre in re-manufactured composites was investigated. A unidirectional glass fibre thermosetting composite laminate was manufactured. The matrix in one part of the laminate was burnt off to recover the glass fibres. These recycled glass fibres were used to manufacture a new composite laminate with the same fibre architecture as the pristine one. The fibres, the matrix and the composite laminates were thoroughly characterised and analysed. The results show that good materials quality was obtained for both laminates. A difference in fibre packing behaviour was observed in the composites with the pristine and the recycled fibres, which lead to a lower fibre volume fraction in the latter one. The Young's modulus of the composites was not changed by the recycling process, if the lower fibre volume fraction is taken into account. However, a marked drop in the maximum stress of the composites was reported, which was found to be related to the loss in maximum stress of the fibres.