Qian Liu

Qian Liu

Auto-generated profile, based on publicly available information

Qian Liu

Faculty of Energy and Environment, Southeast University, Nanjing 211100, China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 July 2022 in ACS Sustainable Chemistry & Engineering
Verified
Journal Article
Closed access
LZLingli Zhu
Lingli Zhu
DSDekui Shen
Dekui Shen
QLQian Liu
Qian Liu
KLKai Hong Luo
Kai Hong Luo
CLChong Li
Chong Li

29 April 2022 in ACS Omega
Verified
Journal Article
Open access
QLQian Liu
Qian Liu
WZWenqi Zhong
Wenqi Zhong
JZJun Zhou
Jun Zhou
ZYZuowei Yu
Zuowei Yu
The co-combustion of biomass and coal has both environmental and economic benefits in terms of pollutants and greenhouse gas emissions. However, one of the key factors affecting the feasibility of this technology is the ash deposition and corrosion caused by the high alkali metal content of biomass, especially K. After the addition of elemental S to corn stalk/Xiaolongtan lignite blended fuel and Al2O3 to corn stalk/Datong lignite, combustion experiments were carried out in a tubular furnace to explore the effects of S and Al in coal on K migration and transformation. The experimental results show that when S/K < 6, an increase in the S/K ratio inhibited the release of K. When S/K > 6, the sulfation become saturated, and an increase in S promoted the release of K. When S/K = 6, the higher the temperature was, and the more obvious the inhibitory effect on the release of K was. Increasing the S/K ratio not only increased the CaSO4 content of the ash but also increased the content of water-soluble K compounds, such as K2SO4, and decreased the contents of acid-soluble K compounds and insoluble K compounds, such as KAlSi3O8. After Al2O3 was added, as the Al/K ratio increased, the K release rate gradually decreased. When the sample with Al/K = 2.5 and the original samples were burned at 600-700 °C, the difference in the K release rates of the two samples was relatively small. When the temperature was higher than 700 °C, the higher the temperature was, and the greater the difference in the K release rates of the samples was, which indicates that a high temperature promotes the formation of aluminosilicates containing K.

20 February 2020 in Waste and Biomass Valorization
Verified
Journal Article
Closed access
PDF file
JWJingzhen Wang
Jingzhen Wang
QLQian Liu
Qian Liu
JZJun Zhou
Jun Zhou
ZYZuowei Yu
Zuowei Yu

13 March 2023 in Biomass Conversion and Biorefinery
Verified
Journal Article
Closed access
PDF file
XTXuecheng Tang
Xuecheng Tang
QLQian Liu
Qian Liu
WZWenqi Zhong
Wenqi Zhong
TWTao Wang
Tao Wang

10 May 2025 in Plants
Verified
Journal Article
Open access
PDF file
YZYifan Zhao
Yifan Zhao
YZYingying Zhu
Yingying Zhu
YRYumeng Ren
Yumeng Ren
YLYu Lu
Yu Lu
CYChunling Yu
Chunling Yu
QLQian Liu
Qian Liu
This study employs near-infrared spectroscopy (NIRS) combined with chemometrics to explore the feasibility and methodology for the rapid analysis of lignocellulosic content in straw. As the demand for biofuels and bioproducts increases, the efficient utilization of agricultural waste, such as straw, has become particularly important. Rapid analysis of lignocellulosic content helps improve the resource utilization efficiency of agricultural waste, providing significant support for biofuel production, agricultural waste valorization, and environmental protection. A total of 148 straw samples were used in this study, collected from Zhejiang, Jiangsu, and Heilongjiang provinces in China, covering rice straw (Oryza sativa L.), corn straw (Zea mays L.), wheat straw (Triticum aestivum L.), soybean straw (Glycine max L.), sorghum straw (Sorghum bicolor L.), rapeseed straw (Brassica napus L.), and peanut straw (Arachis hypogaea L.). After collection, the samples were first air-dried until surface moisture evaporated and then ground and sifted before being numbered and sealed for storage. To ensure the accuracy of the experimental results, all samples were subjected to a 6 h drying treatment at 60 °C before the experiment to ensure uniform moisture content. Partial least squares (PLS) and support vector machine (SVM) regression methods were employed for modeling analysis. The results showed that NIRS in combination with PLS modeling outperformed SVM in the calibration and prediction of lignocellulosic content. Specifically, the cellulose PLS model achieved a prediction set coefficient of determination (R2P) of 0.8983, root mean square error of prediction (RMSEP) of 0.6299, and residual predictive deviation (RPD) of 3.49. The hemicellulose PLS model had an R2P of 0.7639, RMSEP of 1.5800, and RPD of 2.11, while the lignin PLS model achieved an R2P of 0.7635, RMSEP of 0.6193, and RPD of 2.17. The results suggest that NIRS methods have broad prospects in the analysis of agricultural waste, particularly in applications related to biofuel production and the valorization of agricultural by-products.

6 July 2022 in Biomass Conversion and Biorefinery
Verified
Journal Article
Closed access
PDF file
QLQian Liu
Qian Liu
WZWenqi Zhong
Wenqi Zhong
ZYZuowei Yu
Zuowei Yu
JZJun Zhou
Jun Zhou