The exploration of aerosol retrieval synergies from diverse combinations of ground-based passive Sun-photometric measurements with collocated active lidar ground-based and radiosonde observations using versatile Generalized Retrieval of Atmosphere and Surface Properties (GRASP) algorithm is presented. Several potentially fruitful aspects of observation synergy were considered. First, a set of passive and active ground-based observations collected during both day- and nighttime was inverted simultaneously under the assumption of temporal continuity of aerosol properties. Such an approach explores the complementarity of the information in different observations and results in a robust and consistent processing of all observations. For example, the interpretation of the nighttime active observations usually suffers from the lack of information about aerosol particles sizes, shapes and complex refractive index. In the realized synergy retrievals, the information propagating from the nearby Sun-photometric observations provides sufficient constraints for reliable interpretation of both day- and nighttime lidar observations. Second, the synergetic processing of such complementary observations with enhanced information content allows for optimizing the aerosol model used in the retrieval. Specifically, the external mixture of several aerosol components with predetermined sizes, shapes and composition has been identified as an efficient approach for achieving reliable retrieval of aerosol properties in several situations. This approach allows for achieving consistent and accurate aerosol retrievals from processing stand-alone advanced lidar observations with reduced information content about aerosol columnar properties. Third, the potential of synergy processing of the ground-based Sun-photometric and lidar observations, with the in situ backscatter sonde measurements was explored using the data from KAUST.15 and KAUST.16 field campaigns held at King Abdullah University of Science and Technology (KAUST) in the August of 2015 and 2016. The inclusion of radiosonde data has been demonstrated to provide significant additional constraints to validate and improve the accuracy and scope of aerosol profiling. The results of all retrieval setups used for processing both synergy and stand-alone observation data sets are discussed and intercompared.

This study focuses on the comparison of aerosol columnar aerosol optical depth (AOD) and lidar ratios together with vertical profiles of aerosol extinction and backscatter at 532 nm retrieved over the King Abdullah University of Science and Technology (KAUST) campus observation site for the period of 2019–2022 using the Generalized Retrieval of Atmosphere and Surface Properties (GRASP) and Micro-Pulse Lidar Network (MPLNET) approaches. An emphasis is placed on independent analysis of daylight and nighttime retrievals to estimate how strongly the differences in the assumptions of both methods made in the absence of nighttime AOD observations influence the retrieval results. Additionally, two aerosol products provided by GRASP excluding and including the volume depolarization observations at 532 nm provided by MPLNET are analyzed to estimate the potential benefits of usage of depolarization data in aerosol profile retrievals. Overall, both columnar and vertical MPLNET and GRASP products demonstrated a better agreement for daytime retrievals for the GRASP product that excluded the depolarization information. At the same time, inclusion of the volume depolarization observations improved the agreement between MPLNET- and GRASP-estimated values at nighttime, both columnar and vertical. In addition, estimated values of daytime extinction profiles at ground level were compared to assess the impact of the assumption of a constant aerosol vertical distribution in the cutoff zone of lidar observations implied in GRASP. The values estimated by GRASP demonstrated a good agreement with MPLNET, for retrievals both including and excluding volume depolarization information. A seasonal variability in the diurnal cycle of aerosol properties estimated by GRASP over the KAUST site for the period 2019–2022 is presented, analyzed and discussed.

We use the Generalized Retrieval of Aerosol Surface Properties algorithm (GRASP) to compare with dust concentration profiles derived from the NMME-DREAM model for a specific dust episode. The GRASP algorithm provides the possibility of deriving columnar and vertically-resolved aerosol properties from a combination of lidar and sun-photometer observations. Herein, we apply GRASP for analysis of a Saharan dust outburst observed during the “PREparatory: does dust TriboElectrification affect our ClimaTe” campaign (PreTECT) that took place at the North coast of Crete, at the Finokalia ACTRIS station. GRASP provides column-averaged and vertically resolved microphysical and optical properties of the particles. The retrieved dust concentration profiles are compared with modeled concentration profiles derived from the NMME-DREAM dust model. To strengthen the results, we use dust concentration profiles from the POlarization-LIdar PHOtometer Networking method (POLIPHON). A strong underestimation of the maximum dust concentration is observed from the NMME-DREAM model. The reported differences between the retrievals and the model indicate a high potential of the GRASP algorithm for future studies of dust model evaluation.

Pollution haze is a frequent phenomenon in the North China Plain (NCP) appearing during winter when the aerosol is affected by various pollutant sources and has complex distribution of the aerosol properties, while different aerosol components may have various critical effects on air quality, human health and radiative balance. Therefore, large-scale and accurate aerosol components characterization is urgently and highly desirable but hardly achievable at the regional scale. In this respect, directional and polarimetric remote sensing observations have great potential for providing information about the aerosol components. In this study, a state-of-the-art GRASP/Component approach was employed for attempting to characterize aerosol components in the NCP using POLDER/PARASOL satellite observations. The analysis was done for January 2012 in Beijing (BJ) and Shanxi (SX). The results indicate a peak of the BC mass concentration in an atmospheric column of 82.8 mg/m² in the SX region, with a mean of 29.2 mg/m² that is about four times higher than one in BJ (8.9 mg/m²). The mean BrC mass concentrations are, however, higher in BJ (up to ca. 271 mg/m²) than that in SX, which can be attributed to a higher anthropogenic emission. The mean amount of fine ammonium sulfate-like particles observed in the BJ region was three times lower than in SX (131 mg/m²). The study also analyzes meteorological and air quality data for characterizing the pollution event in BJ. During the haze episode, the results suggest a rapid increase in the fine mode aerosol volume concentration associated with a decrease of a scale height of aerosol down to 1500 m. As expected, the values of aerosol optical depth (AOD), absorbing aerosol optical depth (AAOD) and fine mode aerosol optical depth (AOD_f) are much higher on hazy days. The mass fraction of ammonium sulfate-like aerosol increases from about 13% to 29% and mass concentration increases from 300 mg/m² to 500 mg/m². The daily mean PM_2.5 concentration and RH independently measured during these reported pollution episodes reach up to 425 g/m³ and 80% correspondingly. The monthly mean mass concentrations of other aerosol components in the BJ are found to be in agreement with the results of previous research works. Finally, a preliminary comparison of these remote sensing derived results with literature and in situ PM_2.5 measurements is also presented.

The versatile Generalized Retrieval of Aerosol and Surface Properties (GRASP) algorithm exploits the advantages of synergic ground-based aerosol observations such as radiometric (sensitive to columnar aerosol optical and microphysical properties) and lidar (sensitive to vertical distribution of the optical properties) observations. The synergy is possible when the complementary data is mutually constrained by GRASP parametrization that includes, for the first time ever, the degree of linear polarization (DoLP) parameter measured by a polarized sun-sky-lunar AERONET photometer (380, 440, 500, 675, 870, 1020, and 1640 nm) in synergy with the vertical profiles from an elastic lidar (355, 532, and 1064 nm). First, a series of numerical tests is performed using simulated data generated using a climatology of data and ground-based measurements. The inversions are performed with and without random noise for five different combinations of input data, starting from the AERONET-like dataset and increasing to the complex one by adding more information for three aerosol scenarios: I—high aerosol optical depth (AOD) with dominant coarse mode; II—low AOD with dominant coarse mode; III—high AOD with dominant fine mode. The inclusion of DoLP improves (i) the retrieval accuracy of the fine-mode properties when it is not dominant; (ii) the retrieval accuracy of the coarse-mode properties at longer wavelengths and that of the fine-mode properties at shorter wavelengths; (iii) the retrieval accuracy of the coarse-mode real part of the refractive index (up to 36% reduction), but has no effect on the retrieval of the imaginary part; (iv) reduces up to 83% the bias of the sphere fraction (SF) retrieval in coarse-mode dominated regimes; and (v) the root mean square error (RMSE) of the retrieval for most of the parameters in all scenarios. In addition, the addition of more photometer channels in synergy with a three-wavelength elastic lidar reduces the RMSE for the real part (67% in the coarse mode) and the imaginary part (35% in the fine mode) of the refractive index, the single scattering albedo (38% in the fine mode), the lidar ratio (20% in the coarse mode), and the SF (43%).

This research aims to estimate long-term aerosol radiative effects by combining radiation and Aerosol Optical Depth (AOD) observations in Barcelona, Spain. Aerosol Radiative Forcing and Aerosol Forcing Efficiency (ARF and AFE) were estimated by combining shortwave radiation measurements from a SolRad-Net CM-21 pyranometer (level 1.5) and AERONET AOD (level 2), using the direct method. The shortwave AFE was derived from the slope between net solar radiation and AOD at 440, 675, 879, and 1020 nm, and the ARF was computed by multiplying the AFE by AOD at six solar zenith angles (20°, 30°, 40°, 50°, 60°, and 70°). Clear-sky conditions were selected from all-skies days by a quadratic fitting. The aerosol was classified to investigate the forcing contributions from each aerosol type. The aerosol classification was based on Pace and Toledano’s thresholds from AOD vs. Ångström Exponent (AE). The GRASP inversions were performed by combined AOD, radiation, Degree of Linear Polarization (DoLP) by zenith angles from the polarized sun–sky–lunar photometer and the elastic signal from the UPC-ACTRIS lidar system. The long-term AFE and ARF are both negative, with an increasing tendency (in absolute value) of +24% (AFE) and +40% (ARF) in 14 years. The yearly AFE varied from −331 to −10 Wm⁻²τ⁻¹, and the ARF varied from −64 to −2 Wm⁻², associated with an AOD (440 nm) from 0.016 to 0.690. The three types of aerosols on clear-sky days are mixed aerosols (61%), desert dust (10%), and urban/industrial-biomass burning aerosols (29%). Combined with Gobbi’s method, this classification clustered the aerosols into four groups by AE analysis (two coarse- and two fine-mode aerosols). Then, the contribution of the aerosol types to the ARF showed that the desert dust forcing had the largest cooling effect in Barcelona (−61.5 to −37.4 Wm⁻²), followed by urban/industrial-biomass burning aerosols (−40.4 to −20.4 Wm⁻²) and mixed aerosols (−31.8 and −24.0 Wm⁻²). Regarding the comparison among Generalized Retrieval of Atmosphere and Surface Properties (GRASP) inversions, AERONET inversions, and direct method estimations, the AFE and ARF had some differences owing to their definitions in the algorithms. The DoLP, used as GRASP input, decreased the ARF overestimation for high AOD.