5 March 2025 in IEEE Transactions on Power Electronics
This article proposes a parameterized 3D thermal simulation methodology based on physics-informed neural networks (PINNs) to achieve rapid design space exploration for power module thermal design. Leveraging the capability of PINNs to quickly approximate the solutions to the parameterized partial differential equations describing the thermal behavior of power modules, a thermal field simulation framework for a SiC three-phase half-bridge power module is developed for parameterized simulations. After a single unsupervised training session, the PINNs-based model can quickly predict the thermal field distribution results of the power module for different combinations of input parameters. The comparison results show that the PINNs predict results are approximately consistent with both COMSOL numerical simulations and experimental measurements in different combination cases. Moreover, in the task of large design space exploration for parameter optimization, the simulation process can be hundreds of times faster than traditional numerical simulation methods, significantly reducing the time cost required for thermal simulations.
7 July 2023 in IEEE Transactions on Power Electronics
Multiphysics simulation software is indispensable for SiC power module design. Lacking interface between circuit simulation software and thermal-fluid-mechanical simulation software poses challenges for accurate design of the power modules. In this paper, an automated field-circuit coupling simulation method based on the self-developed COMSOL-PSpice interface software is proposed to achieve precise and fast multiphysics co-simulation of multichip SiC power modules. Firstly, the multiphysics coupling mechanism of SiC power modules is analyzed to reveal that the precise and timely data transfer between temperature and power loss is crucial to enabling an accurate multi-software co-simulation. To realize the automatic data transfer between COMSOL and PSpice, a MATLAB-based software interface is developed. Then, a multi-rate and indirect coupling strategy is proposed to improve the simulation accuracy of the developed COMSOL-PSpice software interface and speed up the co-simulation process. To break the limitations of the indirect coupling strategy on simulation accuracy and efficiency with fixed time steps, a variable time step coupling analysis method based on the numerical solution of temperature coupling state variables is proposed. Finally, the proposed field-circuit coupling co-simulation method is verified by simulation and experiment results from a buck converter. The comparison between simulation and experimental results demonstrates the validity of the developed co-simulation interface software, which gives a mismatch below 5% and simulation efficiency 3-5 times higher, if compared to that using fixed time steps.